GAS HOOK-UP
Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement pressure regulator and hose assembly must be specified by the grill manufacturer.
This is a liquid propane configured grill. Do not attempt to use a natural gas supply unless the grill has been
Total gas consumption (per hour) of the
Main burners | 45,000 BTU/Hr. |
Rear burner | 10,000 BTU/Hr. |
Side burner | 15,000 BTU/Hr. |
Total | 70,000 BTU/Hr. |
The installation of this appliance must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, National Gas Propane Installation Code, CSA B149.2.
Installation in Canada must be in accordance with the Standard
LIQUID PROPANE CYLINDER REQUIREMENTS (20 lb. Cylinder)
A dented or rusty liquid propane gas cylinder may be hazardous and should be checked by your supplier. Never use a cylinder with a damaged valve. The liquid propane cylinder must be constructed and marked in accordance with the specifications for liquid propane cylinders by the United States Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA- B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods Commission.
The 20 lb. cylinder must have a shut off valve terminating in a valve outlet specified, as applicable, for connection type QCC1 in the standard for compressed gas cylinder valve outlet and inlet connection
The cylinder supply system must be arranged for vapor withdrawal. The cylinder must include a collar to protect the cylinder valve.
Storage of an outdoor cooking gas appliance indoors is permissible only if the liquid propane cylinder is disconnected and removed from the appliance.
Manifold pressure: (operating) 10 inches water column (W.C.),
The liquid propane cylinder must be fitted with an Overfill Protection Device (OPD).
Remove the plastic valve cover from the liquid propane cylinder. Make sure the grill’s gas hoses do not contact the grease tray or grill firebox when the liquid propane cylinder is pushed into the cart.
CONNECTION
Your grill is equipped with gas supply orifices for use only with liquid propane gas. It is also equipped with a high capacity hose/regulator assembly for connection to a standard 20 lb. liquid propane cylinder
To connect the liquid propane gas supply cylinder:
1.The cylinder valve should be in the “OFF” position. If not, turn the valve clockwise until it stops.
2.Make sure the cylinder valve has the proper type 1 external male thread connections per ANSIZ21.81.
3.Make sure the burner valves are in the “OFF” position.
4.Inspect the valve connections, port and regulator assembly. Look for any damage or debris. Remove debris and inspect the hose for damage.
5.When connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it stops. Use of a wrench could damage the quick coupling nut and result in a hazardous situation
6.Open the cylinder valve fully by turning the valve counterclockwise.
7.Before lighting the grill, use a soap and water solution to check all the connections for leaks.
8.If a leak is found, turn the cylinder valve off and do not use the grill until a local liquid propane dealer can make repairs.
WARNING
Never attempt to use damaged or obstructed equipment. See your local liquid propane dealer for repair.
DISCONNECTION
1.Turn off the burner valves and make sure the grill is cool.
2.Turn off the tank valve by turning the control knob clockwise until it stops.
10