Brinkmann 7741 Series owner manual Proper ground

Step 3

Set upper grill body assembly on the grill base and secure the sides with four M6 X 12mm bolts. Afterwards, secure the back of the grill body assembly with three

M6 X 12mm bolts, three M6 washers three M6 lock washers and three M6 nuts.

Step 4

Remove rotisserie burner cover from rotisserie burner assembly. The bolts and washers removed will be used again in Step 6.

Step 5

Attach gas supply line to pre-installed rotisserie burner orifice using two M4 X 8mm bolts as illustrated.

Step 6

Replace rotisserie burner cover over rotisserie burner assembly and secure. Make sure rotisserie ground wire is inserted under one of the rotisserie burner cover bolts for a

Rotisserie

Burner Cover

Burner

Orifice

M4 X 8mm

Upper Grill Body

Assembly

Ground

Wire

proper ground.

Step 7

Gas Supply

Line

Bolts

Attach the rotisserie burner electrode wire to the igniter module located inside the right door. The connection should be made to the only open terminal.

Igniter

Module

Electrode Wire

Battery Compartment

Step 8

Place hood on the grill and align with holes, then secure hood with hood bolts and cotter pins as shown.

Hood

Cotter Pin

Head Bolt

Location of

Rotisserie

Burner Igniter

25