Grease Tray Bracket
Grill Body
GRILL LIGHTING INSTRUCTIONS: |
|
|
|
| |
1. | Read and follow all warnings and instructions | 5. | Press the electronic igniter and hold for | 7. | Repeat Steps |
| in owner’s manual before lighting. |
| seconds to light burner. |
| use electronic igniter for lighting each burner. |
2. | Open lid before lighting burner. | 6. | If burner does NOT ignite immediately, turn control | 8. | Refer to owner’s manual for match lighting procedure. |
3. | Make sure all control knobs are in the OFF position. |
| knob to OFF, wait 5 minutes to allow gas to | 9. | For assistance, call |
4. | Select the burner to be lit. Push and turn the control |
| dissipate and repeat lighting procedure. | 10. To turn off, turn control knobs clockwise until it locks | |
| knob of that burner to HIGH. |
|
|
| in OFF position. |
FOR OUTDOOR USE ONLY
Igniter Button Cap
|
|
| GRILL LIGHTING INSTRUCTIONS: |
|
|
| |
|
| 1. | Read and follow all warnings and instructions | 5. Press the electronic igniter and hold for | 7. | Repeat Steps | |
|
|
|
| in owner’s manual before lighting. | seconds to light burner. |
| use electronic igniter for lighting each burner. |
|
|
| 2. | Open lid before lighting burner. | 6. If burner does NOT ignite immediately, turn control | 8. | Refer to owner’s manual for match lighting procedure. |
3. | Make sure all control knobs are in the OFF position. | knob to OFF, wait 5 minutes to allow gas to | 9. | For assistance, call | |||
4. | Select the burner to be lit. Push and turn the control | dissipate and repeat lighting procedure. | 10. To turn off, turn control knobs clockwise until it locks | ||||
|
|
|
| knob of that burner to HIGH. |
|
| in OFF position. |
|
| OFF | OFF |
| OFF | OFF | |
| HIGH | HIGH | HIGH |
| HIGH | ||
|
| LOW | LOW | FOR OUTDOOR USE ONLY | LOW | LOW | |
|
|
|
|
|
|
|
|
Step 5
Attach the grease tray bracket onto the back cart panel by inserting the three tabs into the slots on the back cart panel.
Note: When performing Step 6, lift grill body from front and rear panels to avoid injury to hands and fingers.
Step 6
With the help of a friend, place grill body assembly on grill cart. Grill body will rest on upper side sections of cart. Align bolt holes located on the outside of the grill body assembly. Secure using four M6 X12mm bolts. At this point, fully tighten four bolts holding back panel from Step 4.
Note: To install battery, unscrew igniter button cap. Insert battery with positive end towards button. Replace igniter button cap.
22