Brinkmann Outdoor Gas Grill owner manual Lighting Instructions, Match Lighting the Burner

Page 10

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light the burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the OFF position.

3.Turn on the fuel supply by rotating the cylinder valve knob counterclockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE BURNER:

1.Open lid before lighting.

2.Turn on either side of the burner by pressing in and rotating the control knob to the HIGH position.

3.Press and hold the igniter button until the burner ignites.

4. If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 4 until burner ignites.

5.If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Burner" section.

6.Once lit, the other side of the burner can be lit automatically by turning the other control knob to "HIGH".

MATCH LIGHTING THE BURNER:

1.Open lid before lighting.

2.Turn the burner control knobs to OFF.

3.Strike and place a long wooden match through the air holes in the bottom LEFT hand side of the grill to approximately 1/2" (2 to 3 cm) from the burner.

4.Turn on the LEFT burner control knob to the HIGH position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 4 until the burner ignites.

6.Once lit, the other side of the burner can be lit automatically by turning the other control knob to "HIGH".

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

9

Image 10
Contents Save this Manual for Future Reference Important Safety For Your SafetyPage Installation Information Cylinder SpecificationsPage Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Burner Lighting InstructionsMatch Lighting the Burner Breaking in Your Grill Turning OFF the GrillOperating the Grill Preheating the GrillIndirect Cooking To Minimize FLARE-UPSRotisserie Cooking Cooler SinkStorage Area Before Storing Your Grill Cleaning and MaintenanceTransporting and Storage HardwareCooking Grills Burners and VenturisCeramic Briquets Trouble Shooting Problem Possible Causes Burner will not lightGrilling to Proper Temperature CleanlinessHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts BAG Contents Kitchen Bottom Frame Kitchen Bottom Frame Studs Casters Add face panel using four stainless steel sheet metal screws Control panel Venturi Tubes Step Grill Support Frame Tank Hook Bracket Attach the drain hose to threaded end of the drain Brinkmann Stainless Steel Backyard Kitchen Assembled Accessories Gallon PAN & Basket SET ONE-YEAR Limited Warranty