LIGHTING THE SIDE BURNER:
. Open lid before lighting side burner.
2.Make sure control knob is in the "OFF" position.
3.Push and turn side burner control knob to the "HIGH" position.
4.Press the electronic igniter on the main control panel and
hold for
siD_ BURNER
5. If ignition does NOT occur in 5 seconds, turn control knob to_MJIDE "OFF", wait 5 minutes to allow gas to dissipate and repeat
JZT_I_
lighting procedure.
6.To turn off, turn each control knob clockwise until it locks in the "OFF" position.
NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner,
or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.
MATCH LIGHTING THE SIDE BURNER:
1.Open the lid to the side burner before lighting.
2.Turn the burner control knob to "OFF".
3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4.Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.
6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.
NOTE: Observe flame height when lit: Flame should be a Blue/Yellow color between
TURNING OFF THE GRILL:
m 1 W
m 2 0
1.Turn off the cylinder valve.
2.Turn all burner control knobs to the "OFF" position.
NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.
ACAUTION!
•The cylinder valve should always be in the off, or closed, position when the grill is not in use.
To turn off the cylinder valve, turn knob clockwise until it stops.
J
11