Brinkmann 2700 owner manual Match Lighting the Side Burner, Turning OFF the Grill

Page 11

LIGHTING THE SIDE BURNER:

1. Open lid to the side burner before lighting.

2. Turn on the side burner by pressing in and rotating the control knob to the HIGH position.

3. Press and hold the igniter button on the main control panel for 3-5 seconds until the burner ignites.

4. If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 4 until burner ignites.

5.If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Side Burner" section.

MATCH LIGHTING THE SIDE BURNER:

1.Open the lid to the side burner before lighting.

2.Turn the burner control knob to OFF.

3.Strike and place a long wooden match approximately 1/2" (2 to 3 cm) from the burner.

4.Turn the side burner control knob to the HIGH position. The burner should light immediately.

5.If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until the burner ignites.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

NOTE: Observe flame height when lit: Flame should be a Blue/Yellow color approximately 1” high when burner is on “High.”

TURNING OFF THE GRILL:

1. Turn OFF the LP tank valve.

1”

.5”

0”

2.Turn all burner control knobs to the OFF position.

NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION!

The LP tank valve should always be in the off, or closed, position when the grill is not in use.

To turn off the LP tank valve, turn knob clockwise until it stops.

10

Image 11
Contents Gas Stainless Steel Outdoor Grill For Your Safety Important SafetyPage Cylinder Specifications Installation InformationPage Hose and Regulator Installing the LP GAS Cylinder Onto the GrillFilling the LP GAS Cylinder Connecting Hose and Regulator to AN LP GAS Cylinder Checking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Lighting the Side BurnerMatch Lighting the Side Burner Controlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillSide Burner Rotisserie CookingBefore Storing Your Grill Transporting and StorageCastings Cleaning and MaintenanceBurner ASSEMBLY/MAINTENANCE HardwareProblem Possible Causes Burner will not light Trouble ShootingHelpful Hints CleanlinessGrilling to Proper Temperature Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Attach back cart panel by using six M6 X 60mm bolts Tank Tray Assembly Spring Pin Grease Tray Bracket Igniter Button Cap Alignment Step Side Table Screw Holes Tool Drawer Step Pro Series 2700 Assembled Accessories Gallon PAN & Basket SET Warranty