Brinkmann 2210 Series owner manual Lighting Instructions, Lighting the Main Burners

Page 11

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the "OFF" position.

3.Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1. Open lid before lighting burner.

2. Make sure all control knobs are in the "OFF" position.

NOTE: The CENTER BURNER must be lit first, then light the left and right burners.

3. Push and turn the control knob for the CENTER BURNER to the "HIGH" position.

4.Press the electronic igniter and hold for 3–5 seconds to light burner.

5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.If the CENTER BURNER does not ignite using the push-button igniter, wait 5 minutes, see "Match Lighting the Main Burners" section.

7.To light the left and right burners, push and turn control knobs to HIGH. Follow Step 5.

GRILL LIGHTING INSTRUCTIONS:

CENTER BURNER

1.

Read and follow all warnings

4.

Push and turn the control knob for

 

and instructions in owner’s

 

the CENTER BURNER to HIGH.

 

manual before lighting.

5.

Press the electronic igniter and

2.

Open lid before lighting burner.

 

hold for 3-5 seconds to light burner.

3.

Make sure all control knobs are

6.

If ignition does not occur in

 

in the OFF position.

 

5 seconds, turn control knob

 

NOTE: The CENTER BURNER must

 

to OFF, wait 5 minutes to allow gas

 

be lit first, then light the left and

 

to dissipate and repeat lighting

 

right burners.

 

procedure.

 

 

 

ELECTRONIC IGNITER

7.

To light the left and right

9. To turn off, turn each

 

burners, push and turn

control knob clockwise

 

control knobs to HIGH.

until it locks in OFF

 

Follow Step 6.

position.

8.

Refer to owner’s manual

 

 

for match lighting

NOTE: Turn off LP supply

 

procedure.

at cylinder when

appliance is not in use.

FOR US

FOR CALL

8.To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the gas flow from the cylinder.

NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

MATCH LIGHTING THE MAIN BURNERS:

1.Open lid before lighting.

2.Turn the burner control knobs to "OFF".

3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to approximately 1/2" (1 to 2 cm) from the burner.

4.Turn on the FAR LEFT burner control knob to the "HIGH" position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the "HIGH" position.

Lighting Hole

Matchlighter

7. If the burner does not light within the first few attempts of match lighting, there is a problem with the

 

gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the

 

problem is found and corrected. See "Trouble Shooting" section of this manual.

10

Image 11
Contents Gas Porcelain Outdoor Grill For Your Safety Important SafetyTable of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Hose and Regulator Regulator Resetting ProcedureFilling the LP GAS Cylinder Connecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Lighting the Side BurnerMatch Lighting the Side Burner Controlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillSide Burner Rotisserie CookingHelpful Hints CleanlinessGrilling to Proper Temperature Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceBefore Storing Your Grill Cooking GrillsHeat Distribution Plates Transporting and StorageTrouble Shooting Frequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions For Missing PARTS, Please Call Customer Service AT Step Hubcap Tank Heat Shield Plate Place grease cup in middle of hole in heat shield plate Grill Body Assembly Step Hose Side Burner Igniter ProSeries 2210 Assembled Warranty