Teledyne MX300-I manual Sensor Cable Connection to Monitor

Page 17

Portable Oxygen Monitor	Operation

Figure 2-2: Sensor Cable Connection to Monitor

Note: When the MX300-I instrument is used for diffusion sampling (i.e., incubators, tents, etc.), the plastic flow diverter must be removed from the R17MED sensor. If the sensor is used in breathing circuits, etc, the diverter must be used as shown in Figure 2-3.

Figure 2-3: Mounting the Sensor in the Tee Adapter

Teledyne Analytical Instruments

17

Image 17

Contents MX300-I MX300-I About This Manual How To Use This ManualSafety Messages Table of Contents Appendix MX300-I Front View List of FiguresList of Tables MX300-I Front View IntroductionIntroduction MX300-I Applicable StandardsOptions FeaturesTheory of Operation ApplicationsSensor Signal ProcessingIntroduction MX300-I Operation SetupInstalling the R17MED Sensor Sensor Installation or ReplacementSensor Cable Connection to Monitor Mounting V-Mount Adapter InstallationInstalling Batteries Battery InstallationCalibration Sequence CalibrationPortable Oxygen Monitor Operation Setting the Alarms AlarmsOutput 0-1 VDC or RS232 0-1 VDC or RS 232 Digital Output Port Use ProcedureHumidity Gas SamplingPressure TemperatureAnesthetic Gases Discrepancy in ReadingsOxygen Reading Error in a Mixture of Anesthetic Gas Do’s and Don’ts CleaningPortable Oxygen Monitor Operation Operation MX300-I Battery Maintenance General Service InformationOverall Maintenance Calibration Sensor MaintenanceAlarms Pressure Troubleshooting Troubleshooting√ Sensor Ventilate the patient, water Watchdog Error CodesOther Problems with the Instrument Return Authorization for Service Appendix SpecificationsOptional Accessories Spare Parts ListOrders should be sent to Blank Crossover IndexIndex MX300-I