ReliOn Thermometer Taking a Reading, Changing Modes, Recalling Measurements in Memory

Taking a Reading

NOTE: Many pediatricians recommend the use of ear thermometers for children older than 6 months.

1. Press and release the SCAN button. After two seconds,
the system will perform a self-test, Fig. 1, and show the	Fig. 1
last temperature taken along with a flashing “°F” to indicate

the unit is ready for measurement, Fig. 2.

2. Gently insert the probe snugly into the ear canal until a

slight resistance is felt. The thermometer will beep when Fig. 2 the auto-position sensor detects proper placement. If the

unit does NOT beep, gently reposition the thermometer.

NOTE: To disable the auto-position sensor, immediately press the SCAN button after inserting the thermometer into the ear canal.

3. After the unit beeps, press the SCAN button, Fig. 3, and	Fig. 3
promptly release the button. The device will beep once
again after the measurement is complete.
NOTE: If you do NOT press the SCAN button once it is
placed in the ear canal, the thermometer will automatically	Fig. 4
take a measurement in 9 seconds.
4. If the measurement is below 100.4°F (38°C), the
thermometer will beep once and the measurement will be
shown on the display with a happy face symbol, Fig. 4.	Fig. 5

5.If the temperature is 100.4°F (38°C) or above, the thermometer will sound one long beep followed by two short beeps. The measurement will be shown on the display with a sad face symbol to indicate fever, Fig. 5.

6.Thermometer will automatically beep and shut off after approximately 1 minute of non-use.

NOTE: To ensure accuracy,

1.Please wait at least 10 seconds between successive readings.

2.Clean the probe lens before and after each use.

Changing Modes

Temperature readings can be displayed in either Fahrenheit or Celsius. To switch between °F or °C, press and hold the SCAN button. Without releasing, also press the ‘M’ button

and toggle between the modes, Fig. 1 and 2.			Fig. 1
			Fig. 2
Recalling Measurements in Memory
The last 10 measurements taken are automatically
stored into memory. To recall measurements, press
the SCAN button to turn the unit on. After the unit
beeps, press the ‘M’ button to view measurements in	Memory	Index	Fig. 1
memory. Continue to press the ‘M’ button to view the
	Symbol

next previously stored measurement, Fig. 1. The unit will beep each time a recorded measurement is viewed.

Replacing the Battery

Your Instant Ear Thermometer requires one lithium battery, type CR2032. The battery needs to be replaced when the low battery symbol appears on the display.

To replace the battery:

1) Slide the battery cover off.

2) Using a non-metal pointed tool, carefully remove the battery and insert the new battery with the positive (+) side facing up.

3) Replace the battery cover.

NOTE: Please properly dispose the battery away from small children and heat.

8 9