Pride Mobility Jet 1 owner manual Seat Installation, To install the seat, Joystick Installation

Page 22

V . A S S E M B L Y

SEAT INSTALLATION

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.

To install the seat:

1.Position the seat post above the seat tower. See figures 8 and 9.

2.Push the seat down until the latch engages. See figure 9.

3.Plug the controller harness into the connector on the utility tray. See figure 10.

SEAT

TOWER

Figure 8. Seat Tower

JOYSTICK INSTALLATION

If your Jet 1 is equipped with a Dynamic joystick controller (see figure 11), it may have been shipped without the joystick installed in the armrest.

Figure 9. Seat Installation

Figure 10. Controller Harnesses

 

PLUG IN CONTROLLER

 

HARNESSES

 

 

 

SLIDE JOYSTICK

 

 

 

INTO BRACKET

 

Figure 11. Dynamic Joystick Controller

SETSCREW

 

 

 

 

 

Figure 12. Joystick and Bracket

 

 

 

 

 

 

 

 

 

 

 

22

www.pridemobility.com

 

 

US Jet 1 ATS/Rev B/Jul03

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Stylish Design and Premium Performance F E T Y G U I D E L I N E S N T E N T S Introduction N T R O D U C T I O NInformation Exchange Pride Owners Club My Authorized Pride Provider IsS a F E T Y Pre-Ride Safety CheckModifications Tire Inflation Weight LimitationsIncline Information Braking Information Cornering InformationOutdoor Driving Surfaces Freewheel ModeStationary Obstacles Steps, Curbs, etc EMI & RFI Transfers Positioning BeltsInclement Weather Precautions Reaching and Bending BatteriesAlcohol Removable PartsWhere do radio waves come from? EMI-RFI-FREQUENTLY Asked Questions FaqsI . E M I / R F What is the FDA doing about the problem? Are all power chairs susceptible to EMI-RFI?What should I do if my power chair moves unexpectedly? T H E J E T JetRear View Specifications Utility Tray Utility TrayFreewheel Levers To engage or disengage the freewheel featureACTIVE-TRAC System S S E M B L Y Parts List QuantitySeatback Assembly To mount the seatback to the hingeTo install the seat Seat InstallationJoystick Installation Seat Height To install the joystick controllerC O M F O R T a D J U S T M E N T S To change the seat heightArmrest Height Optional Armrest WidthArmrest Angle Joystick ExtensionFootrest Angle Elevating LEG Rests OptionSeat Removal Battery RemovalI . D I S a S S E M B L Y Body Shroud RemovalDynamic DL-50 Controller Battery Condition MeterI I . O P E R a T I O N JoystickJoystick Out Of Neutral At Power Up Pin ConnectorPin Charger Inhibit Connector Speed ControlTroubleshooting Fault CodesBatteries B a T T E R I E S a N D C H a R G I N GCharging the Batteries To charge the batteries using the onboard charger OFF-BOARD ChargerDaily Use Battery BREAK-INTo break in new batteries for maximum efficiency Infrequent UseWhy do my new batteries seem weak? What type of battery should I use?Battery Specifications How can I get maximum range or distance per charge?What about public transportation? How can I ensure maximum battery life?How should I store my Jet 1 and its batteries? What about shipping?A R E a N D M a I N T E N a N C E Routine MaintenanceTemperature Should your Jet 1 come in contact with waterWeekly Checks Daily ChecksTo check the brakes Yearly Checks Cleaning Instructions Tires and TubesMonthly Checks StorageTo replace the batteries Battery ReplacementFollow these easy steps for a quick and safe repair Motor BrushesWhen to see Your Pride Provider for Service Corrective MaintenanceTo inspect or replace the motor brushes O P T I O N a L a C C E S S O R I E S Warranty Exceptions FIVE-YEAR Limited Frame WarrantyONE-YEAR Limited Warranty Warranty ExclusionsThere is no other express warranty Quality Control Model Jet 1 ATS
Top Page Image Contents