Sunrise Medical V-521 Obstacles, Driving in Reverse, RAMPS, Slopes & Side Hills, Beware

Page 9

V I .

G E N E R A L W A R N I N G S

 

 

Q.OBSTACLES

Obstacles you may have to overcome in daily use include door thresholds, lifts,

ramps and hazards such as potholes and broken pavement.These can damage your chair and may cause a fall, tip-over or loss of control.

1.Be aware that thresholds are very dangerous. (Even a small change in height may stop a caster wheel and cause your chair to tip).You may need to:

Remove or cover threshold strips between rooms.

Install a ramp at entry or exit doors.

2.Keep your eyes moving when you ride; scan the area well ahead of your chair.

3.Make sure the floor areas where you use this chair are level and free of obstacles.

4.To help correct your center of balance:

Lean your upper body forward slightly as you go up over an obstacle.

Press your upper body backward as you go down from a higher to a lower level.

R. DRIVING IN REVERSE

Use extra care when you drive your chair in reverse.You may lose control or fall if one of the rear wheels hits an object.

1.Operate your chair slowly and at an even speed.

2.Stop often and check to make sure your path is clear of obstacles.

S.RAMPS, SLOPES & SIDE HILLS

The center of balance of your chair changes when you are on a slope.

Note: “Slope” includes a ramp or side hill.Your chair is less stable when it is at an angle. Never use this chair on a slope unless your are sure it is safe.When in doubt,

have someone help you.

Beware Of:

1.Steep slopes. Do Not use this chair on a slope steeper than 10%. (A 10% slope means: One foot in elevation for every ten feet of slope length).

2.Wet or slippery surfaces (such as when ice, snow, water or oil film is present). A loss of traction may cause a fall or tip-over.

3.A change in grade on a slope (or a lip, bump or depression). These may cause a fall or tip-over.

4.A drop-off at the bottom of a slope. (A drop-off of as small as 3/4 inch can stop a front caster and cause the chair to tip forward).

930485 Rev. A

16

V I . G E N E R A L W A R N I N G S

T. TO REDUCE THE RISK OF A FALL,

 

 

TIP-OVER OR LOSS OF CONTROL:

 

1.

Never use your chair on a slope unless

 

 

you are sure you can do so without

 

 

losing traction.

 

2.

Always go as straight up and as straight

 

 

down as you can.

 

 

• Do not “cut the corner” on a slope

 

 

or ramp.

Fig. 1

Do not turn or change direction on a slope.

3.Always stay in the center of the ramp. Make sure ramp is wide enough that you are not at risk that a wheel may roll off the side.

4.Lean or press your body uphill.This will help adjust for a change in the center of balance caused by the slope. (Fig. 1)

5.Keep your chair moving at a slow, steady speed. Keep control over the chair at all times.

On a descent, do not let your chair accelerate beyond its normal speed.

If the chair picks up speed, center the joystick to slow down or stop.

Note: The solid state controller of your chair has a logic system that will help control your speed when driving on a slope or up hill.

• If you stop, re-start slowly.

6.Never use rear wheel locks to try to slow or stop your chair.This is likely to cause the chair to veer out of control.

17

930485 Rev. A

Image 9
Contents Quickie Sunrise Home Healthcare Group Mobility Products Division Sunrise ListensFor Answers to Your Questions EMI Electromagnetic InterferenceConnecting Batteries in Battery Boxes Check-Out To Find & Correct a ProblemMaintenance Chart Positioning Belts OptionalAdjust Chair to Your Ability Choose the Right Chair & Safety OptionsQuickie Review this Manual OftenWhat Effect can EMI HAVE? What is EMI?Sources of EMI Distance from the SourceController Settings Weight LimitSafety CHECK-LIST Changes & AdjustmentsMotor Vehicle Safety When Seated in a Parked WheelchairEnvironmental Conditions TerrainReaching or Leaning TransfersTo Reduce the Risk AND/OR Damage to the Chair Dressing or Changing ClothesDriving in Reverse ObstaclesRAMPS, Slopes & Side Hills BewareWheelchair Lifts Ramps AT Home & WorkCurbs & Single Steps StairsANTI-TIP Levers ON/OFF SwitchArmrests BatteriesPush Handles Positioning Belts OptionalRear Wheel Locks Optional Seating SystemsTo Descend a Curb or Single Step To Climb a Curb or Single StepTools YOU will Need To Find & Correct ProblemCHECK-OUT SWING-AWAY FootrestsDUAL-POST HEIGHT- Adjustable Armrests Integral Joystick InstallationHEIGHT-ADJUSTABLE Armrests Optional Elevating Legrest OptionalControl Settings Quickie Qtronix Programming PAD OptionalFolding and Unfolding Thermal ROLL-BACK Circuit BreakersIntegral Joystick Introduction Joystick Boot HUse Proper Batteries BreakingConnecting Batteries in Battery Boxes Battery ChargerLift battery into battery box base Tighten all the terminal fasteners using two wrenchesCharging Batteries Make sure to allow enough time to fully charge batteriesDisposing of Batteries Cleaning Battery MaintenanceStorage Tips To Repair or Replace a Tire Maintenance ChartMotor Brushes Ordering PartsFor Life Additional WarrantyLimitations What WE will doSunrise Medical