I X . S E T - U P , A D J U S T M E N T & U S E
I X . S E T - U P , A D J U S T M E N T & U S E
L. BACKREST
A backrest
1.Seat Depth and Angle Adjustment on Seat Frame
a)Remove the front securing bolt (C) on the side of the backrest hinge plate.
b)Loosen the lower rear bolt (D)
c)Set at desired angle.There are four holes (in 4º increments) to choose from.
d)Reinstall the front bolt (C) and tighten both bolts securely.
2.Seat Depth and Angle Adjustment on the Contour Seat
a)The contour seat is shipped with a
b)To increase the
c)To decrease the back height,remove hinge bolt from hole (F) and replace bolt in hole
(G). Do the same for the other hinge.
Note: Adjusting the back height will change the
Note: Adjustment on both sides of the wheel- chair must be equal.
D |
C |
G | E |
| F |
b)Backrest is ready for use.
2.Folding Backrest
a)Fold backrest forward.
N. FOLDING BACKREST (SEAT FRAME)
Folding backrests are shipped with backrest in folded position.
1.Upright Positioning
a)Lift backrest to upright position so that latch handles (F) lock into place.
b)Backrest is ready for use.
2.Folding Backrest
a)Lift and turn backrest latch handles (F) inward or outward.
b)Fold backrest forward.
O. SEAT HEIGHT ADJUSTMENT
1.Contour and Highback Contour Seats The seat height can be adjusted for different seat heights.
a)Remove the seat and shroud cover. For instructions on removing seat, see section IX, P. For instructions on remov- ing shroud, see section IX, Q.
b)Reposition all four of the seat mounts to desired position by removing bolts, adjusting mounts and replacing bolts.
c)Ensure that the top of all seat mounts sit at the same height.
d)Replace shroud and seat.
2.Seat Frame Height Adjustment
F
C B A
3.Adjustment for the Highback Contour Seat
a)Pull lever (H) upwards.
b)Lean back to desired position.
c)Release lever (H).
CAUTION:Backrest latches must be locked into place before operating wheelchair.
M.FOLDING BACKREST (seat frame & Contour seat only)
Quickie
1.Upright Contour Seat Positioning
a)Lift backrest to upright position.
H |
Adjusting the seat height can be done both at the front and at the rear of the seat. Seat angle can also be achieved through front and rear seat adjustment.
Rear Seat Height Adjustment
a) Use positioning holes (A&B) and receiver notch (C).
Front Seat Height Adjustment
a)Use positioning holes (I, II, i, ii) to adjust height.
I
II
i
ii
930484 Rev. A | 32 | 33 | 930484 Rev. A |