I X . S E T - U P , A D J U S T M E N T & U S E
I X . S E T - U P , A D J U S T M E N T & U S E
P.SEAT REMOVAL (CONTOUR & HIGHBACK CONTOUR SEATS)
1.Remove Seat
a)Remove safety
b)Pull down both the right and left release buttons.
c)Flip seat back and remove.
2.Replace Seat
a)Position rear of seat on docking mount.
b)Rotate seat forward until latches lock the seat in place.
c)Replace the safety
Always replace the safety
Q. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove Shroud |
a) Remove deck lid (B). Deck lid is held |
by two pieces of Velcro and one piece |
A
D C
c)Replace screws and tighten. Important Note: If there is any difficulty in
S.SEAT DEPTH (SEAT FRAME AND CONTOUR SEATS ONLY) The seat depth can be adjusted in one inch increments.
1.Seat Frame Depth Adjustment
a)To adjust, remove the two bolts (A) from each side of the backrest pivot plate.
b)Reposition the backrest to the desired position.
c)Replace and retighten bolts on each side of the backrest pivot plate.
2.Contour Seat Depth Adjustment
a)Remove bolts (B) on the seat hingeplate.
b)Adjust the set back to desired position.
c)Refasten bolts (B) in appropriate location.
T.CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly. After the wheelchair has been set up be
A
B
| of Poly Lock (plastic locking Velcro). |
b) | Remove four (4) |
| (C) by turning them 1/4 turn and |
| removing. |
c) | Lift shroud from a central point. |
2. Replace Shroud |
B
sure the chair performs to your specified operational settings (see pages 36- 39). If the chair does not perform to specifications, turn the wheelchair OFF immediately and reprogram operational specifications using the QTRONIX Programming Pad.
Repeat this procedure until the wheelchair performs to specifications before
a)Replace shroud by repositioning shroud on base frame and align the holes with the frame fasteners.
b)Secure 1/4 turn fasteners.
c)Install deck lid and press firmly with thumb at D using support with your forefingers in pocketed area under lid.
R.PARAPAK SEAT SLING (SEAT FRAME)
The seat sling tension can be adjusted through use of the VELCRO® retaining material beneath the seat.
1.Adjustment
a)Remove the screws retaining the left side seat sling.
b)Readjust VELCRO® style material to increase the tension in the seat sling.
attempting active use of the wheelchair.
If you have any problems, follow these procedures:
1.Review the
2.If your problem persists, contact your authorized supplier. If you still have a problem after contacting your authorized supplier, contact Sunrise customer service. See the introduction page for details on how to contact your authorized supplier or Sunrise customer service.
930484 Rev. A | 34 | 35 | 930484 Rev. A |