Installation MRCA/MRWA Adapter Mounting

5.0INSTALLATION

5.1MRCA/MRWA ADAPTER MOUNTING

1.Determine the mounting location. Remember to allow for adequate clearance on all sides of the monitor.

NOTE: When determining the mounting lo- cation, consideration must be given to the total weight of the monitor and the mount. The mounting surface must be adequate to support this weight.

2.Use the adapter mount as a template to mark the required mounting holes.

3.Using the necessary fasteners, attach the adapter mount to the chosen surface.

5.2 MR3050 INSTALLATION

1.Determine the width the base mounting brackets (item 1, Figure 2) must be positioned to in order to accommodate the monitor being used. Next, attach the two (2) bracket supports (item 13, Figure 2) to the base mounting brackets as indicated in Figure 2.

2.Attach the monitor to the base mounting brackets. If the monitor has removable rubber feet, remove the screws from the monitor feet and remove the feet. Use the same hardware to attach the monitor to the base mounting brackets.

3.Thread the 8" (20.32 cm) pipe supplied into the ceiling/wall adapter which has already been in- stalled.

4.Thread collar with cross bar attached onto the end of the 8" (20.32 cm) pipe attached to the ceiling/ wall mount (already installed).

5.Slide the side brackets (item 2, Figure 2) onto cross bar and thread on the 1/4-20 bolts. Don't tighten bolts until all pieces are together.

6.Lift monitor with base pieces attached up to mount. Attach side brackets to base pieces on monitor us- ing the four (4) 3/8-16 bolts supplied.

7.Tighten set screws in upper part of collar to lock mount and collar in place.

8.Tilt the monitor to the desired angle and tighten bolts on each side of adjusting brackets.

9.Make all necessary electrical connections.

PELCO Manual C222M-A (8/95)