Before You Begin
Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 20 minutes for assembly, not including initial charge time.
Allow up to 18 hours for initial charge (see page 3 for charging information)
Charger
WARNING:
DO NOT USE NON- RAZOR PRODUCTS WITH YOUR RAZOR ELECTRIC SCOOTER. The scooter has been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket products may or may not be compatible.
Charger
Plug
Charger
Port
Twist Grip Throttle
Seat (if applicable)
Folding
Mechanism
-Battery
-Motor
-Control Module
Required Tools
2.5mm/4mm/5mm key | 8mm/10mm/17mm | Phillips | Valve extender | |
wrenches | wrenches | screw driver | (Located in right | for Schrader valve tires, |
(Included) | (Included) | (Included) | handlebar grip) | with pressure gauge |
|
| (E200S ONLY) |
| (Not Included) |
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call
2