Repair and Maintenance
qChain and Rear Tire Replacement
Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
1 With a Phillips screwdriver, | 2 With a 10mm wrench, | 3 With two 8mm wrenches, |
loosen the two screws and | loosen the brake cable anchor | loosen brake housing anchor |
remove the chain guard. | and disconnect the cable. | and disconnect. Keep the spacer |
|
| and bolts together. |
4 With a 10mm wrench, loosen | 5 With two 17mm wrenches, | 6 Remove wheel. Note the |
both axle adjusters an equal | loosen the axle. Slide the wheel | sequence of the hardware. |
amount, approximately five | forward to loosen the chain. |
|
turns. |
|
|
7 Install new chain or wheel by | 8 To hook up the brake housing | 9 Install the brake spring and |
maneuvering the chain onto the | anchor, align the cable guide | thread the cable wire into the |
sprocket and slipping the axle | adjuster and install the spacer | cable anchor. Thread the cable |
into the slots on the frame. | and bolt. Do not tighten until | to its original position and |
| final step. | tighten securely. |
Right Side (Throttle)
Spacer
Washer (clipped) Washer (plate cut)
Axle Adjusting Eye Assembly Locknut
Left Side (Brake)
Spacer Washer (flat) Washer (flat) Washer (clipped) Brake Plate
Axle Adjusting Eye Assembly Washer (plate cut)
Locknut
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call
6