Razor E200 Front Tire Replacement, Replace the chain guard, Placement wheel, Clockwise

Page 8

Repair and Maintenance

10 Install the axle adjusters and axle nuts. Tighten until they just barely hold the hardware in place.

13 Replace the chain guard.

11Tighten both axle adjusters the same number of turns to fine- tune the tension on the chain and center the wheel.

12 Tighten the brake housing anchor securely. Test ride and check. Readjust as needed.

qFront Tire Replacement

Tools required: two (2) 17mm wrenches and a flathead screwdriver.

8-1

 

8-3

 

8-2

 

8-2

 

8-6

 

8-5

 

8-1

 

8-2

 

8-2

1 Using two 17mm wrenches,

2 Remove wheel and install re-

loosen the front axle bolts by

placement wheel.

turning the wrenches counter

 

clockwise.

 

7

Right Side (Throttle)

8-3 - (Short) spacer

8-2 - Washer

8-2 - Washer

8-1 - 17mm locknut

Middle

8-6 - Front axle bolt

Left Side (Brake)

8-5 - (Long) spacer

8-2 - Washer

8-2 - Washer

8-1 - 17mm locknut

Image 8
Contents Specifications subject to change without notice Do not Return to StoreContents Safety WarningsEstimated Assembly and Set-Up Time Folding Mechanism Battery Motor Control ModuleBefore You Begin Required ToolsAssembly and Set-Up Battery that will no longer accept a chargeAttaching the Handlebars Inflating the TiresCharging the Battery Attaching the Seat if applicableRepair and Maintenance Chain and Rear Tire Replacement Front Tire Replacement Placement wheelReplace the chain guard ClockwiseAdjusting the Chain Battery Care and DisposalReplacement Parts Repair Centers ChargerTroubleshooting Guide E200 / E200S Scooter parts SB 1918 California Declaration Warranty Razor Limited Warranty
Related manuals
Manual 24 pages 27.16 Kb