I V . A S S E M B L Y
To install the seat:
1. Set the trapeze bars to the desired height. To change the trapeze bar height, see V. “Comfort Adjustments.”
2. Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 10.
3.Lower the front extrusion onto the front trapeze bar until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety is flipped down before using your power chair.
5. | Install the controller into one of the armrests. See V. |
|
| “ComfortAdjustments.” |
|
6. | Route the controller cable so that it cannot be pinched |
|
| in the seat hinge. |
|
7. | Slide the rear cover open to expose the electronics tray. |
|
8. | Plug the controller connector into the electronics tray. | Figure 11. Power Elevating Seat Actuator |
|
|
See figure 6.
9.Secure the controller cable to the armrest receiver with one or more wire ties.
Power Elevating Seat Installation (Optional)
Your power chair may be equipped with a power elevating seat option. While the seat itself may be any one of the styles offered for this model, the way the seat base attaches to the power base is different.
To install the power elevating seat:
l.Align the seat post on the seat base to the hole in the actuator. See figure 11.
2.Insert the seat post into the actuator and push the seat lever forward to lock the seat into place.
3.Plug the power elevating seat switch cable into the con- nector on the electronics tray.
22 | www.quantumrehab.com | Quantum 1122 Series |