Installation Menu

When the PFP Controller is turned on for the first time, the INSTALLATION item will not appear in the main menu. To enable the INSTALLATION menu, there are two options:

·With the processor ON and no menus on-screen, simultaneously press the ENTER, UP and LEFT buttons (you don't need to hold them down). Release the three buttons and press MENU, ensure INSTALLATION is now on the bottom of the main menu.

·With the remote control, press button 6 (with no menus on-screen).

After pressing '6', press MENU and ensure INSTALLATION is now on the bottom of the main menu.

After INSTALLATION has been accessed, press MENU, highlight INSTALLATION and press ENTER. This will bring up the INSTALLATION MENU, shown below:

INSTALLER MODE

SIDE BAR LEVEL

INVERTOFF

OUTPUT SHIFT

INPUT SHIFT

IR CODE SELECT

19

Page 19
Image 19
Runco PL-50HDX, PlasmaWall manual Installation Menu