PL-50HDX Control Panel, STANDBY/ON Indicator

PL-50HDX Control Panel

Plasma

Front View

1.STANDBY/ON Indicator

This indicator is red during standby mode, and turns green when the unit is in the operation mode. It flashes green when Power-Management function is operating. The flashing pattern is also used to indicate error messages.

2.Display Stand

3.Remote Control Sensor Not used.

Page 12

Image 12

Runco PlasmaWall manual PL-50HDX Control Panel, STANDBY/ON Indicator

Contents

PL-50HDX Page Contents Features and Benefits Introduction Avertissement Safety Tips DOC compliance NoticeDOC avis de conformation Limited Warranty What is Covered Under the Terms of this Limited Warranty RIGHTS, Limits and Exclusions Quick Setup Instructions General Overview PL-50HDX Inputs and Controls Synchronizing signal impedance selector switch Main Power switchAudio Input Stereo mini jack Audio Output Stereo mini jack STANDBY/ON Indicator PL-50HDX Control Panel PFP Controller Description Front Panel Rear Panel Remote Control Description Power Button Quick Setup Guide Connecting the Plasma and PFP ControllerPlasma Bottom View ComLink Control Cable DVI Source Connection Examples VCR Menu Description and Navigation Installation Menu Picture Quality Adjustments White Yellow Cyan Green Magenta Red BluePage Side Bar Level ‘43 burn’ System Reset To reset your PFP Controller, follow this procedureImage Shift Aspect Ratios Units tall Units wide Active image area Actual screen area Blanked cut off Areas RS-232 Communications Other notes RS-232 Commands PL-50HDX Plasma Dimensions PFP Controller Dimensions Top PanelSide Panel PL-50HDX Plasma Specifications PFP Controller Specifications Supplied AccessoriesInput standards BandwidthPage RUMA-009800 rev