PL-50HDX INPUTS AND CONTROLS
| AC INLET | ~16 | L |
| 8 | ||
| + – | ||
| SPEAKER |
| |
11 | 12 | 13 |
|
INPUT5
DIGITAL RGB
14
8 | ~16 |
| CONTROL |
| COMBINA TION |
| INPUT1 | (ON SYNC) |
| INPUT2 | (H/V SYNC) |
|
| AUDIO | |||
|
|
| IN | OUT |
|
| OUTPUT | G | B | R | HD | VD |
| INPUT | OUTPUT | ||
SPEAKER | IN | OUT |
| ANALOG RGB | (ANALOG RGB) |
| |||||||||||
R + |
| – |
|
|
|
|
|
|
|
|
| 75 | Ô 2.k 2 | (INPUT1/2) |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
| 1 |
|
| 2 |
| 3 | 4 | 5 | 6 |
|
| 7 |
|
| 8 | 9 10 | |
1SPEAKER (R) terminal
For connection of an external right speaker. Connect a speaker whose impedance is 8
2CONTROL IN/OUT (monaural mini jacks)
For connection of RUNCO components that bear
the SR mark. Making CONTROL connection enables control of the main unit as a component in a system.
NOTE: The main unit cannot be operated by the wired remote control
3COMBINATION IN/OUT
Used when a number of sets are controlled
collectively. Please use a mini DIN 6 pin cable (straight, fully connected) available on the market as the connecting cable.
NOTE: It has no ABL linking function. And it is not compatible with the
4RS-232C
This terminal is used for adjustments by a PC
5INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or component (applies only when equipped with
6OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the video signal to an external monitor or other component.
NOTE:
*The video signal will not be output from the OUTPUT (INPUT1) connector when the main power of this display is off or in standby mode.
*When connecting the main units in a series, please set the number that can be connected as a total of 5 including the set that the signal is initially input to. But a condition for performing separate sink or composite sink input and output is that the sink level of the source used is at least TTL level at 2.2k Ω terminal time.
7INPUT2 (BNC jacks)
For connection of components that have RGB or component (applies only when equipped with
10
