Runco PL-50HDX manual Synchronizing signal impedance selector switch, Audio Input Stereo mini jack

8Synchronizing signal impedance selector switch

Depending on the connections made at INPUT2, it may be necessary to set this switch to match the output impedance of the connected compo- nent's synchronization signal.

When the output impedance of the component's

synchronization signal is below 75 Ω, set this switch to the 75 Ω position.

9AUDIO INPUT (Stereo mini jack)

Use to obtain sound when INPUT1, INPUT2 or INPUT5 (applies only when equipped with

PL-50HDX) is selected. Connect this jack to the audio output connector of the device connected to the plasma display's INPUT1 or INPUT2, or to the audio output connector of the device connect- ed to the video card's INPUT5 (applies only when equipped with PL-50HDX).

10AUDIO OUTPUT (Stereo mini jack)

Use to output the audio of the selected source component connected to the main unit to an AV amplifier or similar component.

11MAIN POWER switch

Use to switch the main power or the main unit on and off.

12AC INLET

A power cable is furnished with the main unit: connect one end of the power cable to this connector and the other end to a standard AC power source.

13SPEAKER (L) terminal

For connection of an external left speaker. Connect a speaker that has an impedance of 8 -16 Ω.

Video Card Section

(applies only when equipped with PL-50HDX)

14INPUT5 (DVI-D jack)

Use to connect a computer.

NOTE: This unit does not support the display of copyguard-protected video signals.

11