Heath Zenith 598-1347-00 Receiver Information, Indoor Plug-InConverter, Halogen FloodLight

Receiver Information

All receivers have the following features and ratings:

•Rated for 120VAC/60Hz supply voltage.

•Not for use with Compact Fluorescent bulbs.

•When first turned on wait 15 seconds.

Indoor Plug-In Converter

Features and Ratings:

• Up to 300 Watt maximum incandescent load.

• No wiring required.

1. Plug in indoor receiver.

2. Plug in light you wish to control.

Caution: Do not exceed the maximum load limits listed above.

3.Check operation. Activate transmitter being used with receiver (see transmitter instructions).Asignal will be sent to the receiver to turn the receiver ON or OFF.

4.Using Remote By-Pass Switch. These receivers are equipped with a remote by-pass switch. This switch allows the user to select between AUTO and MANUAL modes. AUTO mode allows the light to be operated by remote control or remote motion sensor. MANUAL mode allows the plugged in light to be operated manually.

5.Adjust audio alert volume. The alarm sounds only when the receiver is activated by the wireless motion sensor and entry switch. The alarm volume is adjusted by the thumbwheel on the side of the receiver unit.

Remote

By-Pass

Switch

	Alarm Volume
Speaker	Control
Control Locations

Halogen FloodLight

Features and Ratings:

• Up to 200 Watt Maximum Tung- sten Halogen (Up to 100 Watt Maximum each bulb holder.)

•Minimal wiring required.

•Bulb Saver™ - Extends bulb life by up to 4x standard bulbs.

Lights bulb to full bright in under 2 seconds.

•Install fixture in accordance with local codes.

CAUTION: Keep the sensor at least 2" (51 mm) away from the bulbs.

CAUTION: To Avoid Fire Or Burn Hazards:

•Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures.

•Keep fixture at least 2" (51 mm) from combustible materials.

Do not aim at objects closer than 3' (1 m).

•Replacement Bulb - Use only T4 100W (max.), G8 tungsten halogen bi-pin 120 VAC bulbs.

Bulb Installation and Replacement

Note: Bulbs are included, but you will need to install them.

Note: When replacing bulbs, turn power off and let the fixture cool.

•To remove lamp shade, loosen set screw 2 full turns with a small flat-head screwdriver. Turn shade counterclockwise and remove.

•To remove bulb, pull straight out of fixture.

•To replace bulb, push bulb pins into bulb socket. Check that the bulb is seated properly.

•To reinstall lamp shade, place shade on fixture and align notches on shade with tabs on fixture. Turn clockwise. Tighten set screw firmly.

598-1347-00