Pride Mobility Quantum 1122 3SP, Quantum 1122 4MP, 1122 3SP, 1122 4MP manual

Page 33

V I I . B A T T E R I E S A N D C H A R G I N G

WARNING! If the battery charger has not been tested and approved for outdoor use, then do not expose it to adverse or extreme weather conditions. If the battery charger is exposed to adverse or extreme weather conditions, then it must be allowed to adjust to the difference in environmental conditions before use indoors. Refer to the manual supplied with the battery charger for more information.

To charge the batteries using the off-board charger:

1.Position the front of your power chair next to a standard electrical outlet.

2.Turn off the power to the controller and engage the manual freewheel lever(s) in the drive position. See III. “Your Power Chair.”

3.Plug the 3-pin extension cable from the off-board battery charger into the off-board battery charger/programming socket on the controller.

4.Plug the off-board battery charger into the electrical outlet.

NOTE: If it is a Pride off-board charger, then there are two lights in it. The red light indicates that power to the off-board charger is on. The green light indicates that the batteries are fully charged. If it is not a Pride off- board charger, then follow the instructions supplied by the manufacturer.

.

5. When the batteries are fully charged, disconnect the charger from the electrical outlet, then from the controller.

To charge the batteries using the onboard charger:

1.Position the rear of your power chair next to a standard electrical outlet.

2.Be certain the controller power is turned off and the freewheel levers are in the engaged position. See III. “Your Power Chair.”

3.Slide the rear cover forward.

4.Extend the charger power cord and plug it into the electrical outlet.

NOTE: The power chair incorporates an inhibit function that disables the power chair when the charger is plugged into an electrical outlet.

5.We recommend you charge the batteries for 8 to 14 hours. As the batteries charge, the ammeter needle slowly drops to zero.

NOTE: The ammeter indicates how much charge is needed to fully charge the batteries. Wait about a minute for the charger to warm up. The ammeter may move as high as 5.5 amps, then gradually move back down to 0 amps as the batteries charge.

6.When the batteries are fully charged, the needle vibrates on or near the zero mark on the ammeter scale. Unplug the power cord from the electrical outlet, wind it up using the hook and loop strap, and place the cord back into the electronics tray.

Quantum 1122 Series

www.quantumrehab.com

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Quantum Quick Reference Information F E T Y G U I D E L I N E SIII N T E N T SN T R O D U C T I O N SafetyPURCHASER’S Agreement Shipping and DeliveryPride Owners Club S a F E T Y Product Safety SymbolsS a F E T Y Pre-Ride Safety Check General GuidelinesModifications Weight Limitations Tire InflationIncline Information Freewheel Mode Braking InformationCornering Information Inclement Weather Precautions Public Streets and Roadways Outdoor Driving SurfacesStationary Obstacles Steps, Curbs, etc Doors Stairs and EscalatorsElevators Lift/Elevation ProductsBatteries Object you are transferring onto TransfersPrescription Drugs/Physical Limitations Alcohol/SmokingElectromagnetic and Radio Frequency Interference EMI/RFI I . Y O U R P O W E R C H a I R Quantum 1122 Series Power ChairSpecifications Needs recharging Electronics TrayRear Suspension Active-Trac SuspensionTo operate the dual manual freewheel levers Dual Manual Freewheel LeversInitial Assembly Seat InstallationA S S E M B L Y To install the seat Power Elevating Seat Installation OptionalTo install the power elevating seat You may need the following to make comfort adjust- ments Comfort AdjustmentsSeat Height/Angle Adjustment O M F O R T a D J U S T M E N T STo adjust the seatback angle Manual Recline Seatback AdjustmentHeadrest Height Adjustment Seat PositionArmrest Width Adjustment Seatback Angle AdjustmentArmrest Height Adjustment Armrest Angle AdjustmentController Position To extend the controllerTo change the controller position Foot Platform Depth Adjustment Foot Platform Height AdjustmentFoot Platform Angle Adjustment Swing-away Footrests OptionalElevating Leg Rests Optional Anti-Tip Wheel AdjustmentAnti-Tip Wheel Adjustment Inner Lock Nut Power Elevating Seat Adjustment OptionalPower Elevating Seat Operation To operate the power elevating seat through toggle SwitchTo use the swivel feature D I S a S S E M B L Y Seat RemovalFoot Frame Removal I . B a T T E R I E S a N D C H a R G I N G Batteries and ChargingCharging The Batteries To charge the batteries using the onboard charger To charge the batteries using the off-board chargerFrequently Asked Questions FAQs Battery Break-InWhy do my new batteries seem weak? What type of battery should I use?How can I ensure maximum battery life? How can I get maximum range or distance per charge?How should I store my power chair and its batteries? What about public transportation?What about shipping? Should your power chair come in contact with water Care and MaintenanceTemperature I I . C a R E a N D M a I N T E N a N C EWeekly Checks Daily ChecksTo check the brakes Monthly ChecksCleaning Instructions Disposal of Your Power ChairWheel Replacement StorageTo replace the batteries Battery ReplacementCorrective Maintenance When to See Your Quantum Rehab Specialist for ServiceW a R R a N T Y Warranty Exclusions Reconditioned Units WarrantyService Checks and Warranty Service Exclusions also include components with damage caused byT E S T E S T E S Page Quality Control Quantum 1122 Series
Top Page Image Contents