Pride Mobility Revo owner manual Assembly

Page 34

I X . D I S A S S E M B L Y A N D A S S E M B L Y

ASSEMBLY

1.Position the front and rear sections of your scooter as shown in figure 20.

2.Align the locking brackets of the front section with the corresponding pegs on the front of the rear section.

WARNING! Position the front-to-rear harness so it will not become pinched between the frame halves when pivoting the rear section forward.

3.Holding the seat post, slowly pivot the rear section forward until the locking brackets are fully connected onto the rear pegs. See figures 19 and 20.

4.Raise the tiller.

5.Secure the toggle latch. See figure 18.

!Lower the toggle latch buckle.

!Push back on the toggle latch so it locks into place.

6.Connect the front-to-rear harness.

7.Reinstall the battery packs and engage both battery pack locks. Always replace the right battery pack first.

8.Replace the seat.

9.Unlock the tiller by rotating the tiller lock knob 90 degrees counterclockwise.

WARNING! Before getting onto your scooter always check that the tiller lock knob is in the unlocked position. Attempting to ride your scooter with the tiller lock knob in the locked position can result in personal injury.

34

www.pridemobility.com

Revo

Image 34

Contents Ultimate In Style & Performance F E T Y G U I D E L I N E S N T E N T S IIIPURCHASER’S Agreement SafetyN T R O D U C T I O N Information ExchangeProduct Safety Symbols S a F E T YModifications GeneralRemovable Parts S a F E T Y Tire Inflation PRE-RIDE Safety CheckWeight Limitations Incline InformationMaximum Recommended Incline Angles With Oxygen Tank Cornering Information Braking InformationOutdoor Driving Surfaces Correct Curb ApproachFreewheel Mode Inclement Weather PrecautionsStairs and Escalators Elevators Battery Disposal and RecyclingDoors LIFT/ELEVATION ProductsMotor Vehicle Transport Reaching and BendingPrescription DRUGS/PHYSICAL Limitations Positioning BeltsAlcohol I . E M I / R F Electromagnetic and Radio Frequency Interference EMI/RFISpecification S Standard SeatingScooter Dimensions O U R S C O O T E R Tiller ConsoleHorn Button Rear SectionBattery Packs OFF-BOARD Battery Charger Voltage Switch Reading Your Battery VoltageB a T T E R I E S a N D C H a R G I N G Charging the Batteries on the Scooter Charging the Batteries OFF of the Scooter Follow these easy steps to charge your batteries safelyTo charge the batteries off of the scooter What if my scooter’s batteries won’t charge? Frequently Asked QuestionsHow does the charger work? How often must I charge the batteries?What type and size of battery should I use? Battery ReplacementWhy do my new batteries seem weak? What about public transportation?Before Getting Onto Your Scooter PRE-RIDE Adjustments and ChecksI . O P E R a T I O N Getting Onto Your ScooterPower Down Timer Feature Getting OFF of Your ScooterI I . C O M F O R T a D J U S T M E N T S Tiller Angle AdjustmentArmrest Width Adjustment Seat RotationFRONT-TO-BACK Seat Adjustment Seat Height AdjustmentDisassembly D I S a S S E M B L Y a N D a S S E M B L YToggle Latch Release Assembly Diagnostic Flash Codes A S I C TroubleshootingWhat if all the systems on my scooter seem to be dead? What if the main circuit breaker repeatedly trips? C a R E a N D M a I N T E N a N C E Wheel ReplacementCleaning and Disinfection Tire PressureAxle Bearings and the MOTOR/TRANSAXLE Assembly Battery Terminal ConnectionsWiring Harnesses Fuse ReplacementStoring Your Scooter Light Bulb ReplacementNylon Lock NUT Replacement Disposal of Your ScooterI . W a R R a N T Y Service Checks and Warranty Service Implied WarrantiesT E S INFMANU2427