Pride Mobility Revo Battery Terminal Connections, Wiring Harnesses, ABS Plastic Shrouds

X I . C A R E A N D M A I N T E N A N C E

BATTERY TERMINAL CONNECTIONS

!Make certain that the terminal connections remain tight and uncorroded.

!The batteries must sit flat in the battery wells.

WIRING HARNESSES

!Regularly check all wiring connections.

!Regularly check all wiring insulation, including the charger power cord, for wear or damage.

!Have your authorized Pride Provider repair or replace any damaged connector, connection, or insulation that you find before using your scooter again.

ABS PLASTIC SHROUDS

!The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are coated with an advanced formula urethane paint.

!A light application of car wax will help the shrouds retain their high gloss.

AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY

These items are all prelubricated, sealed, and require no subsequent lubrication.

MOTOR BRUSHES

The motor brushes are housed inside of the motor/transaxle assembly. They should be inspected periodically for wear by your authorized Pride Provider.

CONSOLE AND REAR ELECTRONICS

!Keep these areas free of moisture.

!Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.

FUSE REPLACEMENT

In the event a fuse should cease to work:

1.Remove the fuse by pulling it out of its slot.

2.Examine the fuse to be sure it is blown. See figures 21 and 21A.

3.Insert a new fuse of the proper rating.

WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure to use properly rated fuses may cause damage to the electrical system and may result in personal injury.

Figure 21. Working Fuse Figure 21A. Blown Fuse (Replace)

38 www.pridemobility.com Revo