V I . B A T T E R I E S A N D C H A R G I N G
Follow these easy steps to charge your batteries safely:
1.Position your scooter close to a standard electrical outlet.
2.Remove the key from the key switch.
3.Make certain that the manual freewheel lever is in the drive (pushed back) position.
4.Remove the charger power cord receptacle cover from the charger power cord receptacle and plug the
5.Make sure the battery charger switch is in the “off” position. See figure 8B.
6.Extend the charger power cord and plug it into the electrical outlet.
7.Turn the charger on. See figure 8B. It is recommended that you charge your batteries for 8 to 14 hours.
8.When the batteries are fully charged, turn the charger off and unplug the charger power cord from the electrical outlet and then from the charger power cord receptacle.
9.Replace the charger power cord receptacle cover.
NOTE: There is a charger inhibit function on your scooter. The scooter will not run and the battery condition meter will not operate if the charger power cord is not disconnected from the battery pack.
CHARGING THE BATTERIES OFF OF THE SCOOTER
Removing the battery packs and charging them off the scooter is convenient should you want to leave the scooter in your vehicle.
To charge the batteries off of the scooter:
1.Remove the battery packs from the scooter and place them on a flat, dry surface in exactly the same positions as they are on the scooter.
2.Follow steps
3.Reinstall the batteries onto the scooter See IX, “Disassembly and Assembly” for information on how to remove and position the battery packs.
Figure 8. Charger Power Cord Receptacle
PLUGS INTO THE CHARGER
POWER CORD RECEPTACLE
ON/OFF SWITCH | PLUGS INTO |
| ELECTRICAL |
| OUTLET |
| I |
| O |
Figure 8A. Off-Board Charger
OFF | ON |
Figure 8B. Charger On/Off Switch
24 | www.pridemobility.com | Revo |