V I . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to several different heights. See figure 18.
1.Remove the seat and/or shroud from your scooter. See VII. “Disassembly and Assembly.”
2.Remove the seat height adjustment bolt.
3.Raise or lower the upper seat post to the desired seat height.
4.While holding the upper seat post at that height, match up the locating holes in the upper seat post with those of the lower seat post.
5.Insert the seat height adjustment bolt through the locating holes of both the upper and lower seat posts.
6.Reinstall the nut onto the seat height adjustment bolt and tighten.
7.Reinstall the rear shroud and the seat.
ARMREST ANGLE ADJUSTMENT
There is an armrest adjustment dial on the underside of each armrest. See figure 19. Turn the armrest adjustment dial to the left to lower the armrest angle or to the right to raise the armrest angle..
NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.
SEAT ROTATION ADJUSTMENT
The seat rotation lever will secure the seat into several positions.
1.Pull upward on the seat rotation lever to disengage the seat. See figure 19.
2.Rotate the seat to the desired position.
3.Release the lever to secure the seat into place.
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the seat forward or rearward to adjust the distance between the seat and the tiller.
1.Move the seat sliding lever located at the lower left side of the seat outward. See figure 19.
2.While holding the lever out, slide the seat forward or rearward.
3.Release the seat sliding lever once the seat is in the desired position.
| UPPER SEAT POST | |
| LOCATING HOLE | |
NUT |
| |
LOWER | SEAT HEIGHT | |
ADJUSTMENT BOLT | ||
SEAT POST | ||
|
Figure 18. Seat Height Adjustment
BOLTS | SEAT ROTATION LEVER |
ARMREST |
|
ADJUSTMENT |
|
DIAL |
|
SEAT SLIDING LEVER |
|
Figure 19. Armrest Width Adjustment
Victory Sport | www.pridemobility.com | 33 |