Pride Mobility INFMANU3676 manual On/off key turns the system on and off

Page 14

14

Basic Operation Instructions

 

 

Keypad

The keypad is located directly in front of the joystick. It contains keys that you will use to control your power chair. See figure 2.

On/Off Key

The on/off key turns the system on and off.

WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair. This will cause the power chair to stop abruptly.

WARNING! Always turn the power off when you are stationary to prevent unexpected movement.

NOTE: If the joystick is not in the neutral (center) position when you turn on the power, you may cause a fault in the system. See “Out Of Neutral At Power Up (OONAPU).”

Horn Key

The horn key activates a warning horn.

Battery Condition Meter

The battery condition meter consists of eight lights arranged in an arc over the on/ off key. As the battery voltage drops, the number of lights reduces from right to left. When the battery capacity drops to 10% or below, the left red LED will flash.

!Left Red LED Flashing: The battery charge is low; charge the batteries as soon as possible.

!Right-to-Left Ripple of LEDs: The controller is in lock mode; unlock the controller.

!Left-to-Right Ripple of LEDs Alternating with Steady Display: The controller is in programming, inhibit, or charging mode. When the joystick is moved, the speed gauge will also flash.

Dynamic Controller

www.pridemobility.com

Image 14
Contents Dynamic Controller Safety Guidelines Table of Contents Product Safety Symbols Label InformationInformation Exchange IntroductionPURCHASER’S Agreement My authorized Pride Provider Is Precautionary Guidelines Dynamic ControllerElectromagnetic and Radio Frequency Interference EMI/RFI Dynamic Controller Features Dynamic Controller Components and Connections Operating the Dynamic Controller Joystick ControlDynamic Controller 4-key Keypad Dynamic Controller 8-key Keypad On/off key turns the system on and off Speed Keys OFF-BOARD CHARGER/PROGRAMMING Socket Controller ConnectorLock Mode Actuator Adjustment To unlock the Dynamic controllerError Codes Sleep Mode if EnabledOUT of Neutral AT Power UP Oonapu Care and Maintenance Warranty Error Code Probable Cause Possible SolutionINFMANU3676