V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 18.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
To change the controller position:
1.Turn off the power to the controller.
2.Loosen the rear shroud fasteners and remove the rear shroud.
3.Unplug the controller connector from the power base.
4.Remove any wire ties securing the controller har- ness to the armrest.
5.Flip up the armrest so it is perpendicular to the floor.
6.Loosen the setscrew on the controller bracket
7.Slide the controller out of the armrest.
8.Loosen the setscrew in the other armrest.
9.Place the controller in the other armrest.
10.Tighten the setscrew to secure the controller.
11.Route the controller harness to the back of the power base and plug in the controller. See figure 13.
12.Replace the rear shroud and tighten the fasteners.
13.Secure the controller harness to the armrest with wire ties. See figure 13.
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
CONTROLLER BRACKET
SETSCREW
Figure 18. Underside of Armrest
MOUNTING BLOCK |
MOUNTING SCREWS |
SETSCREWS |
Figure 19. Adjusting Controller Position (Mounting Block)
Quantum 6000 Series | www.pridemobility.com | 27 |