V I I . C A R E A N D M A I N T E N A N C E
WHEEL HUB |
LUG NUTS |
Figure 25. Quantum 6000 Drive Wheel
TIRE |
TUBE |
FRONT RIM HALF |
SCREWS |
REAR RIM HALF |
Figure 26. Quantum 6000 Drive Wheel Disassembled
Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1.Turn off the power to the controller.
2.Set the power chair up on blocks.
3.If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4.Remove the (5) lug nuts from the wheel hub. See figure 25.
5.Pull the wheel off of the hub.
6.Remove the screws and separate the front and rear rim. See figure 26.
7.Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is a solid tire.
8.Screw together the two rim halves.
9.Slide the wheel back onto the hub.
10.Reinstall the five (5) lug nuts onto the wheel hub and tighten.
11.Inflate the pneumatic tire to the psi/bar/kPa air pressure rating indicated on each tire.
12.Remove the power chair from the blocks.
Battery Replacement
A battery wiring diagram is printed on a decal located on the front battery tray. See the specification table for correct battery specifications.
MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! The batteries in your power chair should only be serviced or replaced by an authorized Pride Provider or a qualified technician.
WARNING! Do not replace batteries when seat is occupied.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Use proper lifting techniques and avoid lifting beyond your capacity.
WARNING! Do not mix old and new batteries. Always replace both batteries at the same time.
Quantum 6000 Series | www.pridemobility.com | 37 |