V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat, you can change the seat height either through the controller or through a toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See figure 23.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches the top or bottom limit.
NOTE: For more information on operating the power elevating seat through the controller, contact your Quantum Rehab Provider.
WARNING! The power elevating seat option is intended for use on a level surface only. Never raise the seat from
its lowest position on an inclined |
| ||||
surface. Failure to heed this warning |
| ||||
Figure 23. Power Elevating Seat Toggle Switch | |||||
can result in the power chair tipping | |||||
over. |
|
|
|
| |
WARNING! Never raise the seat from |
| ||||
its lowest position when operating |
| ||||
your power chair on bumpy or uneven |
| ||||
surfaces. Failure to heed this warning |
| ||||
can result in the power chair tipping |
| ||||
over. |
|
|
|
| |
WARNING! Never raise the power |
| ||||
elevating seat while your power chair |
| ||||
is in the freewheel mode. |
|
| |||
WARNING! | Always | fasten | the |
| |
positioning | belt when | operating | the |
|
power elevating seat.
NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by one half when the seat is elevated more than
Quantum 6000 Series | www.pridemobility.com | 29 |