V I . C O M F O R T A D J U S T M E N T S
Once you are familiar with your Jazzy’s operation, you may find the need to adjust your seating position. There are some adjust- ments you can make to increase your comfort, such as seat height and angle, armrest height and angle, footrest height and angle, and joystick position.
WARNING! If your Jazzy 1100 was configured at your authorized Pride provider or service cen- ter, please consult your health care professional before changing the seat position or making any other adjustment. Some adjustments may de- grade your Jazzy’s performance and safety by changing its center of gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height by one of two ways: either manu- ally or automatically. (If equipped with the optional Power El- evating Seat, see “Power Elevating Seat Option.”)
To change the seat height:
1.Remove the seat. See VII. “Disassembly” in this manual.
2.Remove the shroud.
3.Remove the ball detent pin from each seat tower. See figure 17.
4.Raise or lower each seat tower to the desired position.
5.Install the ball detent pin into each seat tower.
6.Reinstall the shroud.
7.Reinstall the seat.
To change the seat angle:
1.Remove the seat hinge bolts with a
2.Adjust seatback to desired angle and reinsert the seat hinge bolts.
3.Tighten bolts with the hex key and wrench.
ARMREST WIDTH
To change the armrest width:
1.Locate the two knobs on the armrest receiver bracket. See figure 19.
2.Loosen the knobs and slide the armrests in or out to the de- sired width.
3.Tighten the knobs.
EACH SEAT TOWER
HAS A BALL
DETENT PIN
Figure 17. Seat Tower Pin
SEAT
HINGE
BOLT
Figure 18. Seat Angle
Figure 19. Armrest Width
TURN THIS SCREW
TO CHANGE
ARMREST ANGLE
JAM NUT LOCKS
ADJUSTMENT
SCREW IN PLACE
Figure 20. Armrest Angle
Jazzy 1100/RevJ/Feb03 | www.pridemobility.com | 23 |