V I I I . O P E R A T I O N
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller was preprogrammed at the factory for five drive programs— 1(slowest) to 5(fastest). The drive mode is indicated by a number in the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your authorized Pride provider changes these settings, please make note of these changes.
To change the drive mode program:
1.Press the drive mode select key.
2.Move the joystick right to increase the drive mode program.
3.Move the joystick left to decrease the drive mode program.
4.Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a
Actuator Select Keys with Lights
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate them through the remote keypad. Contact your authorized Pride provider for information on how to operate these accessories.
Remote Status Light
This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred. See “Out Of Neutral At Power Up.”
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance to conserve battery power.
Off-board Charger/Programming Socket
You may use an
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the
Jazzy 1100/RevJ/Feb03 | www.pridemobility.com | 39 |