V . C O M F O R T A D J U S T M E N T S
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicu- lar to the floor. See figure 13.
2.Loosen the jam nut.
3.Turn the adjusting screw to raise or lower the front of the armrest.
4.Tighten the jam nut to lock the adjusting screw into place.
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 13.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off power to the controller.
2.Disconnect the controller from the power base.
3.Cut the wire tie(s) securing the controller harness to the armrest.
4.Flip up the armrest so it is perpendicular to the floor.
5.Loosen the setscrew on the controller bracket. See figure 13.
6.Slide the controller out of the armrest.
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrew to secure the controller.
10.Route the controller harness so that it cannot be pinched in the seat hinge.
11.Use wire ties to secure the controller harness to the armrest. See figure 10.
12.Plug the controller into the power base. See figure 6.
CONTROLLER BRACKET
SETSCREW
Figure 13. Underside of Armrest
MOUNTING HARDWARE
Figure 14. Foot Platform Height Adjustment
24 | www.pridemobility.com | Jazzy 1170 XL Plus Series |