Foot Platform Height Adjustment

V . C O M F O R T A D J U S T M E N T S

The foot platform height is easily adjusted to six different heights.

To raise or lower the foot platform:

1.Use a hex key to remove the mounting hardware from the foot platform. See figure 14.

2.Raise or lower the foot platform to the desired height.

3.Reinstall the mounting hardware into the foot platform.

Foot Platform Angle Adjustment

You can adjust the angle of the foot platform with a hex key.

To adjust the foot platform angle:

1.Locate the setscrew on the underside of the foot plat- form. See figure 15.

2.Turn the setscrew to raise or lower the front of the foot platform.

SETSCREW

Figure 15. Foot Platform Angle Adjustment

Anti-Tip Wheels

The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the following occur:

When coming to a stop, your power chair tips forward excessively.

The anti-tip wheels constantly rub the ground.

WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip wheel height! Changing the anti-tip wheel height affects handling under deceleration!

WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s tendency to tilt forward while decelerating. You can compensate for this by having your authorized Pride Provider make a small adjustment to the pre-programmed deceleration setting in the controller or by moving the seat assembly farther to the rear of your power chair.

PROHIBITED! Do not remove the anti-tip wheels.

To adjust the anti-tip wheels:

1.Place a wrench on the inner locknut of the anti-tip bracket located right in front of the shock strut. See figure 16.

2.Turn the locknut counterclockwise to loosen the cam.

3.Place your wrench on the adjustable cam located on the other side of the locknut.

4.To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the cam clockwise. See figure 17.

5.Tighten the locknut.

NOTE: Each drive tire must be inflated to the psi/bar/kPa air pressure rating indicated on the tire for pneumatic tires. The user must also be seated in the power chair in order to properly adjust the anti-tip wheels.

Jazzy 1170 XL Plus Series