Walking Tutor
Assembly, Installation and Operating Instructions
Model No. WT 200
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe and proper installation of the WT200 walking tutor, these instructions MUST be followed:
WARNING
DO NOT use this equipment without first reading and understanding this instruction sheet. If you are unable to understand the warnings, cautions and instructions, contact a healthcare professional, dealer or technical personnel if applicable, before attempting to install this equipment - otherwise, injury or damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products.
Assembling the Walking Tutor
Tools required:
•9/16 Open End Wrench
•16mm Box End Wrench
•19mm Box End Wrench
•13mm Socket Wrench
•16mm Socket Wrench
•18mm Socket Wrench
•5mm Allen Key
•6mm Allen Key
Attaching Strap Assemblies to the Boom
NOTE: For this procedure, refer to FIGURE 1 on page 2.
1.Remove the boom cover to expose the boom crossbar (Detail “C”).
2.Secure the strap assembly on the crossbar by placing the strap around crossbar and inserting the buckles through the loop (Detail “A”).
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Part No 1141439 | 1 | Walking Tutor |