DETAIL “A” | Boom Bearing | DETAIL “B” | |
|
| ||
| Retainer | Bearing Block | Socket Head Screws |
|
|
| |
Allen Key
Pivot |
|
Assembly | Mast |
| |
|
|
DETAIL “C” | DETAIL “D” |
Bearing Blocks | Walking Tutor |
Bearing Blocks |
Socket Head
Screws
Walking Tutor |
|
| Locknut | Pivot |
|
|
| ||
Mast |
|
| Assembly | |
Bearing Block | Actuator |
| ||
|
|
FIGURE 3 Attaching the Walking Tutor to the Lift
Assembling the Armrest to Walking Tutor
NOTE: For this procedure, refer to FIGURE 1 on page 2 and FIGURE 4 on page 5.
1.Attach straps to walking tutor arm assembly (FIGURE 1 on page 2).
2.Level the walking tutor arm by using the hand pendant. Refer to Using the Walking Tutor on page 6.
3.Remove the lever from the walking tutor arm and remove the spacer (not shown).
4.Insert the spacer into the armrest assembly tube.
5.Insert the armrest assembly tube with the spacer inside into the walking tutor arm.
6.Align the hole in the spacer with the walking tutor arm and replace the lever and tighten in place.
7.Pull out the lever to position it.
Walking Tutor | 4 | Part No 1141439 |