SECTION
SECTION 8—BACK
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
Adjusting the Back Height
NOTE: For this procedure, refer to FIGURE 8.1.
NOTE: Back canes must be adjusted to the same height.
1.R32 Model ONLY: Remove the two (2) bottom back upholstery mounting screws securing the back upholstery to the wheelchair frame.
2.Remove the two (2) mounting screws and locknuts that secure the two (2) back canes to the back cane mounting tube.
3.Reposition the back canes to the desired height adjustment position.
4.Reinstall the mounting screws and locknuts that secure the back canes to the wheelchair frame and securely tighten.
5.Reinstall the two (2) bottom back upholstery mounting screws securing the back upholstery to the wheelchair frame.
Back | Back Cane |
Upholstery | Wheelchair |
| |
| Frame |
Upholstery
Mounting Screw
Locknut
Mounting
Screw
Back Height (in inches)
* HOLE # | 1 | 2 | 3 |
|
|
|
|
HEIGHT | 16 | 17 | 18 |
|
|
|
|
*NOTE: Holes numbered from bottom to top for reference only. There are no numbers on the back canes or wheelchair frame.
FIGURE 8.1 Adjusting the Back Height
Nutron® Series | 40 | Part No.1106644 |