Invacare Nutron Series manual Adjusting/Replacing Telescoping Front Rigging Support

SECTION 6—FRONT RIGGINGS

4.Perform one (1) of the following:

• Adjusting:

NOTE: Telescoping front rigging supports may be extended up to 2‐inches from the wheelchair frame in 1‐inch increments. This adjustment does not effect seat depth.

i.Position the telescoping front rigging support to the desired depth.

•Replacing:

i.Remove the existing telescoping front rigging support from the wheelchair frame.

ii.Insert the new telescoping front rigging support into the wheelchair frame.

iii.Position the telescoping front rigging support to the desired depth.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

5.Using the front and rear socket bolts and two (2) locknuts, secure the telescoping front rigging support to the wheelchair frame as shown in FIGURE 6.7.

6.Using the long socket bolt and locknut, secure the H‐block and spacer to the wheelchair frame and the telescoping front rigging support as shown in FIGURE 6.7.

7.Snap crossbraces into H‐blocks. Wiggle crossbraces to make sure they are secured in the H‐blocks.

8.If necessary, repeat STEPS 1‐8 on remaining telescoping front rigging support.

H-Block

Wheelchair Frame			Locknuts
			Do Not Use With
			Front Socket Bolt
Rear Socket Bolt
Long Socket Bolt		Spacer	Telescoping Front
		2-inch	Rigging Support
	Front Socket Bolt
		1-inch
			0-inch
	Front Socket Bolt Positions
	(Depth)

FIGURE 6.7 Adjusting/Replacing Telescoping Front Rigging Support

Nutron® Series 36 Part No.1106644