Invacare Nutron Series manual Installing/Removing the Anti-Tippers

SECTION 15—ANTI-TIPPERS

SECTION 15—ANTI-TIPPERS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

Installing/Removing the Anti-Tippers

WARNING

Anti-tippers MUST be fully engaged and spring buttons fully protruding out of adjustment holes BEFORE using the wheelchair.

Ensure both anti-tippers have the same ground clearance.

A 1½ to 2-inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.

Anti-tippers MUST be used at all times. When outdoors on wet, soft ground or gravel surfaces, anti tippers may not provide the same level of protection against tipover. Extra caution must be observed when traversing such surfaces.

NOTE: For this procedure, refer to FIGURE 15.1.

Installing

1.Press the two (2) release buttons in and insert the anti‐tippers with anti‐tipper wheels pointing toward the ground/floor into the support tubes until the release buttons lock in place.

2.Measure the distance between the bottom of the anti‐tipper wheels and the ground/floor.

3.If the distance between the bottom of the anti‐tipper wheels and the ground/floor is not 1½‐2‐inches, do not use the anti‐tippers. Replace anti‐tippers and repeat STEPS 1 and 2.

Removing

1. Press release buttons in and remove the anti‐tippers from the support tubes.

Part No.1106644 67 Nutron® Series