Invacare Nutron Series manual Using the Proper Batteries

Page 47

SECTION 12—BATTERIES

SECTION 12—BATTERIES

Warnings for Handling and Replacing Batteries

WARNINGS

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Make sure power to the wheelchair is off before performing this section.

The use of rubber gloves and chemical goggles or face shields is recommended when working with batteries.

Invacare strongly recommends that battery installation and battery replacement ALWAYS be done by a qualified technician.

ALWAYS use a battery lifting strap when lifting a battery. It is the most convenient method and assures that the battery acid will not spill. It also helps to prolong the life of the battery.

DO NOT tip the batteries. Keep the batteries in an upright position.

NEVER allow any of your tools and/or battery cable(s) to contact BOTH battery posts at the same time. An electrical short may occur and serious personal injury or damage may occur.

The POSITIVE (+) RED battery cable must connect to the POSITIVE (+) battery terminal, otherwise serious damage will occur to the electrical system.

NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the battery(ies), apply baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new battery(ies), clean the baking soda from the battery tray or battery(ies) being sure to avoid contact with skin and eyes. Determine source of contamination. Never install/reinstall a battery with a cracked or otherwise damaged case.

Using the Proper Batteries

NOTE: For this procedure, refer to FIGURE 12.1.

1.Place battery on ground/flat surface.

2.Visually draw a horizontal and vertical centerline through the middle of battery (FIGURE 12.1).

3.Position the battery so that the terminals are above the horizontal centerline.

4.Visually inspect the battery to ensure the correct position of the POSITIVE and NEGATIVE terminals (FIGURE 12.1).

Part No.1106644

47

Nutron® Series

Image 47
Contents Nutron Series Nutron Series Part No.1106644 Table of Contents Back UPHOLSTERY/SEAT Positioning Strap Complete and mail the form on the next Register Your ProductProduct Registration Form Fold here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Restraints Special NotesNutron R32, R32LX Typical Product ParametersOperating Information Repair or Service InformationGeneral Guidelines Tire Pressure Electrical AccessoriesCharging Batteries Grounding InstructionsBatteries Rain Test Weight TrainingWeight Limitation EMI Information EMI Information Coping With Everyday Obstacles SAFETY/HANDLING of WheelchairsSafety/Handling of Wheelchairs Stability and BalanceTilting Curbs TiltingStairways Escalators Transferring To and From Other SeatsReaching, Leaning and Bending Forward Percentage of Weight DistributionReaching and Bending Backward Reaching and Bending BackwardInspect/Adjust Weekly Safety INSPECTION/TROUBLESHOOTINGSafety Inspection Checklists Inspect/Adjust InitiallyInspect/Adjust Periodically Inspect/Adjust MonthlySymptom Probable Cause Solutions Troubleshooting GuideDON’T Checking Battery Charge LevelOperating the Wheelchair Turning the Power On/OffWheelchair Operation Using the Horn Using the Joystick to Drive the ChairSPJ Joystick Switches and Indicators Display Description Definition Removing Installing/Removing the FootrestsInstalling Front RiggingsModel PW93, PW93E, and PW93ST Footrests Adjusting the Footrest HeightModel 93M, 904A, PAL4A, and PAS4A Footrests Replacing Heel LoopsRaising/Lowering Elevating Legrests Installing/Removing Elevating LegrestsAdjusting Calfpads Adjusting/Replacing Telescoping Front Rigging SupportAdjusting/Replacing Telescoping Front Rigging Support Arms Adjusting Armrest HeightClothing Guard Using Swing-Back ArmsArmrest Pad Removing/Installing Armrest Removing/Installing ArmrestBack Adjusting the Back HeightReplacing Back Upholstery UPHOLSTERY/SEAT Positioning StrapReplacing Seat Upholstery Replacing Back Upholstery Replacing Seat Positioning StrapReplacing Seat Positioning Strap Preparing the Joystick For Use JoystickRepositioning the Joystick Repositioning the JoystickCasters Adjusting ForksBatteries Using the Proper BatteriesUsing the Proper Batteries Recommended Battery TypesInstalling/Removing the Battery Boxes Installing/Removing the Battery Boxes Installing/Removing the Battery TrayInstalling/Removing the Battery Tray Place batteries into battery box bottom Direct Mount Method Connecting Battery CablesBatteries Connecting Battery Cables Direct Mount Method Connecting Battery Cables Battery Clamp Method Battery Clamp MethodInstalling Battery Clamp Cover Connecting Battery Cables -Battery Clamp Method Replacing the Battery Box Retaining Strap 10 Replacing the Battery Box Retaining Strap Cleaning Battery TerminalsCharging Batteries When To Charge BatteriesConnecting the Battery Charger Description and Use of Battery ChargersEngaging/Disengaging the Clutches CLUTCH/MOTOR LockCLUTCH/MOTOR Lock Wheel Locks Installing/Adjusting/Using the Wheel LocksInstalling/Adjusting Installing/Adjusting/Using the Wheel Locks UsingANTI-TIPPERS Installing/Removing the Anti-TippersInstalling/Removing the Anti-Tippers Unfolding/Folding the Wheelchair TransportingTransporting the Nutron Transporting the Nutron Limited Warranty USA