Invacare Auriga10 user manual Seat Lifter Button, Status display

Page 25

6.1.1Seat Lifter Button

•Press the button to activate the Seat Lifter (if installed). The LED above the button lights up.

•Raise or lower the seat using the throttle lever.

•Press the button once again to de-activate the Seat Lifter. The throttle lever reverts back to driving mode.

NOTE

If the Seat Lifter is not lowered entirely, then the speed of the scooter is automatically reduced to lower the risk of tipping over. This is indicated by the LED just above the "Reduced Speed Mode" button flashing. Lower the Lifter completely to restore speed to it's normal level. The LED will go out.

6.1.2Status display

NOTE

The leftmost diode of the battery charge display serves as an error message display (status display). For an explanation of the Error Codes please see chapter "Error Codes and Diagnostic Codes" on page "30".

25

Image 25

Contents Auriga10 Deutschland Danmark How can you get in touch with Invacare?Portugal Table of Contents Care and maintenance Repair Instructions Adjustment OptionsAdjusting the position of the seat from front to back Electrical SystemDismantling the scooter for transport Technical Specifications Inspections PerformedRemoving a front wheel 3-Wheel Version 11.1Dear user IntroductionPage This symbol warns you of danger Important symbols in this manualRequirements Type Classification and Area of Use General Safety Notes Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Before driving for the first time DrivingDriving up over an obstacle Correct Taking ObstaclesDriving down off of an obstacle IncorrectDriving up and down gradients Activating and de-activating the parking brake option Parking and stationaryActivating the brake Releasing the brakeDisengaging Motors Pushing the scooter by handEngaging the motor Control Panel layout Control PanelStatus display Seat Lifter ButtonBattery charge display Driving the Scooter Diagnostics and Trouble Shooting Contact your authorised Invacare Dealer Diagnosing FaultsCount the number of flashes and refer to the next section Number Fault Impact on Flashes Scooter Error Codes and Diagnostic CodesNumber Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjusting the angle of the backrest Adjustment OptionsAdjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electronics Protection System Electrical SystemMain fuse BatteriesWhat you need to know about batteries Page Charging the batteries Disconnecting the scooter from the mains power supply Connecting the scooter to a mains power supplyHow can I tell when the batteries are fully charged? Disconnecting the charger Connecting the chargerAfter contact with skin Removing and fitting batteriesAfter contact with eyes Removing the batteries Requirements Disposing of dead or damaged batteries correctly Cleaning the vehicle Care and maintenanceCleaning Maintenance JobsSeat and backrest padding TyresRepair Instructions Repairing a flat tyreRe-assembly Repairing a flat tyre pneumatic tyres type 260 xRemoving a rear wheel Requirements Having trouble removing the wheel?Removing a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Requirements 3-Wheel Version front wheel Repairing the flat tyre Requirements GeneralDid the old inner tube get wet during repair? Removing the seat Dismantling the scooter for transportRemoving the batteries Removing the batteries and the Drive UnitRemoving the Drive Unit Weight Technical SpecificationsElectrical System Dimensions Range according to ISO 7176 Driving attributesInspections Performed English