Invacare Auriga10 user manual Adjustment Options, Adjusting the angle of the backrest

Page 33

7 Adjustment Options

7.1Adjusting the angle of the backrest

The backrest is held in place by a metal plate on each side. Each plate has 4 holes that are used to set the backrest to different angles. This is done by selecting different combinations of holes.

Requirements:

•Allen key, 4 mm

•Spanner, 10 mm

•Remove the screws on both sides of the seat that hold the backrest (1), using the spanner and Allen key.

•Adjust the backrest to the desired angle.

•Reposition the screws and tighten.

33

Image 33

Contents Auriga10 Deutschland Danmark How can you get in touch with Invacare?Portugal Table of Contents Care and maintenance Repair Instructions Adjustment OptionsAdjusting the position of the seat from front to back Electrical SystemDismantling the scooter for transport Technical Specifications Inspections PerformedRemoving a front wheel 3-Wheel Version 11.1Dear user IntroductionPage Important symbols in this manual This symbol warns you of dangerRequirements Type Classification and Area of Use General Safety Notes Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Before driving for the first time DrivingDriving up over an obstacle Correct Taking ObstaclesDriving down off of an obstacle IncorrectDriving up and down gradients Activating and de-activating the parking brake option Parking and stationaryActivating the brake Releasing the brakePushing the scooter by hand Disengaging MotorsEngaging the motor Control Panel layout Control PanelStatus display Seat Lifter ButtonBattery charge display Driving the Scooter Diagnostics and Trouble Shooting Diagnosing Faults Contact your authorised Invacare DealerCount the number of flashes and refer to the next section Number Fault Impact on Flashes Scooter Error Codes and Diagnostic CodesNumber Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjusting the angle of the backrest Adjustment OptionsAdjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electronics Protection System Electrical SystemBatteries Main fuseWhat you need to know about batteries Page Charging the batteries Connecting the scooter to a mains power supply Disconnecting the scooter from the mains power supplyHow can I tell when the batteries are fully charged? Disconnecting the charger Connecting the chargerRemoving and fitting batteries After contact with skinAfter contact with eyes Removing the batteries Requirements Disposing of dead or damaged batteries correctly Cleaning the vehicle Care and maintenanceCleaning Maintenance JobsSeat and backrest padding TyresRepair Instructions Repairing a flat tyreRe-assembly Repairing a flat tyre pneumatic tyres type 260 xRemoving a rear wheel Requirements Having trouble removing the wheel?Removing a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Requirements 3-Wheel Version front wheel Repairing the flat tyre Requirements GeneralDid the old inner tube get wet during repair? Removing the seat Dismantling the scooter for transportRemoving the batteries Removing the batteries and the Drive UnitRemoving the Drive Unit Technical Specifications WeightElectrical System Dimensions Range according to ISO 7176 Driving attributesInspections Performed English