Invacare Auriga10 user manual Pushing the scooter by hand, Disengaging Motors, Engaging the motor

Page 23

5 Pushing the scooter by hand

The motors of the scooter are equipped with automatic brakes, preventing the scooter from rolling away out of control when the power supply is switched off. When pushing the scooter, the magnetic brakes must be disengaged.

5.1Disengaging Motors

Danger of the vehicle running away!

•When the motors are disengaged (for push operation), the electromagnetic motor brakes are deactivated! When the vehicle is parked, the levers for engaging and disengaging the motors must without fail be locked firmly into the "DRIVE" position (electromagnetic motor brakes activated)!

The lever for engaging and disengaging the motor is located on the right at the rear of the scooter.

Disengaging the motor

•Make sure the power supply is switched off (key switch).

•Push lever (1) forwards.

Engaging the motor

•Pull lever backwards.

23

Image 23

Contents Auriga10 Deutschland Danmark How can you get in touch with Invacare?Portugal Table of Contents Electrical System Adjustment OptionsCare and maintenance Repair Instructions Adjusting the position of the seat from front to back11.1 Technical Specifications Inspections PerformedDismantling the scooter for transport Removing a front wheel 3-Wheel VersionDear user IntroductionPage Requirements Important symbols in this manualThis symbol warns you of danger Type Classification and Area of Use General Safety Notes Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Before driving for the first time DrivingIncorrect Taking ObstaclesDriving up over an obstacle Correct Driving down off of an obstacleDriving up and down gradients Releasing the brake Parking and stationaryActivating and de-activating the parking brake option Activating the brakeEngaging the motor Pushing the scooter by handDisengaging Motors Control Panel layout Control PanelStatus display Seat Lifter ButtonBattery charge display Driving the Scooter Diagnostics and Trouble Shooting Count the number of flashes and refer to the next section Diagnosing FaultsContact your authorised Invacare Dealer Number Fault Impact on Flashes Scooter Error Codes and Diagnostic CodesNumber Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjusting the angle of the backrest Adjustment OptionsAdjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electronics Protection System Electrical SystemWhat you need to know about batteries BatteriesMain fuse Page Charging the batteries How can I tell when the batteries are fully charged? Connecting the scooter to a mains power supplyDisconnecting the scooter from the mains power supply Disconnecting the charger Connecting the chargerAfter contact with eyes Removing and fitting batteriesAfter contact with skin Removing the batteries Requirements Disposing of dead or damaged batteries correctly Cleaning the vehicle Care and maintenanceTyres Maintenance JobsCleaning Seat and backrest paddingRepair Instructions Repairing a flat tyreHaving trouble removing the wheel? Repairing a flat tyre pneumatic tyres type 260 xRe-assembly Removing a rear wheel RequirementsRemoving a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Requirements 3-Wheel Version front wheel Repairing the flat tyre Requirements GeneralDid the old inner tube get wet during repair? Removing the seat Dismantling the scooter for transportRemoving the batteries Removing the batteries and the Drive UnitRemoving the Drive Unit Electrical System Technical SpecificationsWeight Dimensions Range according to ISO 7176 Driving attributesInspections Performed English