Invacare Auriga10 user manual Removing a front wheel 3-Wheel Version Requirements

Page 53

10.1.1.3 Removing a front wheel (3-Wheel Version)

Requirements:

•2 Spanners, 17 mm

•Tilt the scooter over on it's side.

•Remove the bolts that hold the wheel (1) using the two spanners, then remove the wheel from the fork.

Re-assembly

Re-assembly is done in reverse order. Make sure that the wheel runs in the same direction it did before it was removed.

53

Image 53

Contents Auriga10 Deutschland Danmark How can you get in touch with Invacare?Portugal Table of Contents Care and maintenance Repair Instructions Adjustment OptionsAdjusting the position of the seat from front to back Electrical SystemDismantling the scooter for transport Technical Specifications Inspections PerformedRemoving a front wheel 3-Wheel Version 11.1Dear user IntroductionPage Requirements Important symbols in this manualThis symbol warns you of danger Type Classification and Area of Use General Safety Notes Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Before driving for the first time DrivingDriving up over an obstacle Correct Taking ObstaclesDriving down off of an obstacle IncorrectDriving up and down gradients Activating and de-activating the parking brake option Parking and stationaryActivating the brake Releasing the brakeEngaging the motor Pushing the scooter by handDisengaging Motors Control Panel layout Control PanelStatus display Seat Lifter ButtonBattery charge display Driving the Scooter Diagnostics and Trouble Shooting Count the number of flashes and refer to the next section Diagnosing FaultsContact your authorised Invacare Dealer Number Fault Impact on Flashes Scooter Error Codes and Diagnostic CodesNumber Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjusting the angle of the backrest Adjustment OptionsAdjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electronics Protection System Electrical SystemWhat you need to know about batteries BatteriesMain fuse Page Charging the batteries How can I tell when the batteries are fully charged? Connecting the scooter to a mains power supplyDisconnecting the scooter from the mains power supply Disconnecting the charger Connecting the chargerAfter contact with eyes Removing and fitting batteriesAfter contact with skin Removing the batteries Requirements Disposing of dead or damaged batteries correctly Cleaning the vehicle Care and maintenanceCleaning Maintenance JobsSeat and backrest padding TyresRepair Instructions Repairing a flat tyreRe-assembly Repairing a flat tyre pneumatic tyres type 260 xRemoving a rear wheel Requirements Having trouble removing the wheel?Removing a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Requirements 3-Wheel Version front wheel Repairing the flat tyre Requirements GeneralDid the old inner tube get wet during repair? Removing the seat Dismantling the scooter for transportRemoving the batteries Removing the batteries and the Drive UnitRemoving the Drive Unit Electrical System Technical SpecificationsWeight Dimensions Range according to ISO 7176 Driving attributesInspections Performed English