Troubleshooting | Harmar Mobility AL065 manual

TROUBLESHOOTING:

PROBLEM: The lift will not operate or operates slowly.

Possible Causes:

Bad Connection—Verify the vehicle wiring harness is tightly attached to the battery and that there is no build up on the terminals.

Battery—Check to see if the battery needs to be replaced or if the terminals are corroded. Clean the terminals if any corrosion is present. 12 volts should be present at the lifting or rotational motors from the vehicles battery. This can be tested with a voltage meter.

PROBLEM: Intermittent power to the lift. The lift will operate for a short period of time and quit. At a later time it will start working again.

Possible Causes:

Circuit Breaker—Although the breaker resets itself automatically, it may be malfunctioning and need to be replaced. Check for power at the lift with a test lamp.

Bad Connection—Verify the vehicle wiring harness is tightly attached to the battery and that there is no build up on the terminals.

Hand Control—Test by bypassing the hand control. Do this for only a second or two. The lift, vehicle, scooter or chair may be damaged if continuous power is left supplied to the unit.

PROBLEM: Lifting arm is slow to swing in / out. (AL400 only)

Possible Causes:

Dirty Bushings—Clean and apply new grease to the white plastic bushing that is located in the Base.

Bad Connection—Verify the vehicle wiring harness is tightly attached to the battery and that there is no build up on the terminals.

PROBLEM: The lifting strap operates in reverse.

Possible Causes:

The lifting strap was overextended. The lifting strap was lowered too far, causing the strap to wind around the spool backwards. Lower the strap until it unravels from the spool. Then, raise the strap in the proper direction.

PROBLEM: AL400 rotates in wrong direction when installed on the passenger side of the vehicle.

Possible Causes:

The lift is shipped from the factory to be mounted on the drivers side of the vehicle. To change the rotation for the passenger side remove the bolt located near the bottom of the post, rotate the motor 180 degrees and reinsert the bolt. Next, change the rotation of the motor located in the base by switching the wires on the motor to reverse the polarity.

PROBLEM: The scooter or chair tips to the front or back while it is being lifted.

Possible Causes:

The scooter or chair is being lifted off center. The docking device should center the lifting strap over the center of gravity which is generally around the center of the seat. Check to make sure the proper docking device is being used.

AL065 specifications

Harmar Mobility AL065 is a state-of-the-art vertical platform lift designed to enhance accessibility for individuals with mobility challenges. This exceptional product is perfect for both residential and commercial settings, offering an efficient vertical solution that allows seamless movement between different levels, especially where traditional ramps may not be feasible.

One of the standout features of the AL065 is its robust construction, equipped with a durable aluminum frame that ensures longevity and stability. This design not only provides strength but also keeps the lift lightweight, making installation easier. The lift's platform has a generous size, accommodating various mobility devices such as wheelchairs and scooters, making it versatile for different users.

The AL065 emphasizes safety, boasting a range of features including a non-slip platform surface and automatic safety barriers that prevent accidental falls. Its advanced control system is user-friendly, featuring a simple-to-operate control panel that can be accessed from both the upper and lower levels of the lift. Additionally, the lift ensures safety during operation with its emergency stop button and optional battery backup, allowing continued functionality even during power outages.

In terms of technology, the Harmar AL065 incorporates advanced hydraulic systems that provide smooth lifting and lowering actions. This technology minimizes noise during operation, contributing to a more pleasant experience. The lift is also designed with a weather-resistant finish, making it suitable for both indoor and outdoor applications.

The compact design of the AL065 allows for installation in tight spaces, and with its range of height options, it can accommodate different building specifications. Furthermore, the lift adheres to all applicable safety standards, ensuring peace of mind for users and installers alike.

Overall, the Harmar Mobility AL065 is a reliable and efficient solution for improving accessibility, combining functionality with user-centric design. Its modern features and technologies make it an excellent choice for those in need of a vertical lift, promoting independence and ease of movement within any environment. Whether for home use or in commercial settings, the AL065 stands out as a leader in mobility solutions.