Installing the AL065
Caution: Carefully read and follow each of the following steps each time you assemble the lift. Failure to do so can result in damage to the lift, vehicle, chair, or injury to the installer/ operator.
1. Unpack the AL065’s shipping box and identify the Arm Assembly with hitch adapter bolted to it hitch.
2. Insert the Hitch Adapter into the vehicles trailer hitch. Bolt the Hitch Adapter to the hitch using the 
sure to tighten the bolts sufficiently. 
3.The Arm Assembly may be adjusted sideways (Fig. 1), inverted (Fig. 2), or switched to a driver side application (Fig. 3).
Fig. 1
Fig. 2
Fig. 3
4.Insert the post into the hole at the end of the Arm Assembly. The post does not have a specified top or bottom so either end may point up. The post is equipped with two rotation limit collars. These collars prevent the lift from rotating too far. Rotate the post so that the lower collar drops down around the arm assembly.
Caution: Pinch points exist at both rotation limit collars. Always stay clear of these areas.
5.Place the power frame on the top of the post. Rotate the frame so that it drops down into the rotation limit collar at the top of the post.
6.The arm assembly, rotation limit collars, and power frame have a strip of red material on them. To ensure that the lift is assembled correctly, rotate the power frame and vertical post until all of the red stripes line up vertically.
4