MIX N' GO MIXER — ASSEMBLY INSTRUCTIONS
6.Tip mixer onto mouth as shown in Figure 10, and insert support stand into frame swivel point.
9.Before attempting to lift mixer, locate the frame locking clip. AttachthelockingclipasshowninFigure12.Thiswillprevent the mixing drum from moving when the mixer is positioned in an upright position.
Figure 12. Frame Locking Clip
10. DO NOT tilt the mixer on a wet, smooth or slippery surface.
Figure 10. Attaching Support Stand
7.Remove both wheels and wheel retainers from the packing container.
8.Place one wheel on each side of the mixer's axle as shown in Figure 11. Position wheel retainer over axle to secure wheel in place. Use a rubber mallet when striking wheel retainer.
Figure 13. Slippery or Wet Surfaces
11. Oncethestandhasbeenassembled,andthelockingcliphas been secured, begin tilting the mixer to an upright position. Remember always tilt from the front of the mixer as shown in Figure 14.
Figure 11.Wheels and Wheel Retainers
Figure 14.Tilting Mixer to Upright Position
PAGE 20