■NEVER Run engine without air cleaner. Severe engine damage may occur.
■ALWAYS read, understand, and follow procedures in Operator’s Manual before attempting to operate equipment.
■ALWAYS be sure the operator is familiar with proper safety precautions and operations techniques before using roller.
■ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.
■NEVER leave the mixer unattended, turn off engine or electric motor when unattended.
■CAUTION must always be observed while servicing this mixer. Rotating parts can cause injury if contacted.
■Unauthorized equipment modifications will void all warranties.
■Ensure that any trailing cable is protected against damage and not liable to be tripped over or trapped underneath the mixer.
■Ensure any extention cables must be no longer than 30 meters (100 feet) in length and that the wire section is 2.5 mm 2.
■DO NOT allow extension cord to come into contact with water or fluids.
■DO NOT spray water onto electric motor.
■DO NOT expose power tools to rain or wet conditions.
■This mixer is intended for the production of concrete, mortar and plaster. Mixer must be used only for its intended purpose.
■This mixer is not suitable for the mixing of flammable or explosive substances.
■NEVER operate the mixer in an explosive atmosphere.
■Before starting the mixer, check that all guards are in position and correctly fitted.
■DO NOT tip mixer onto drum mouth when the motor is running.
■Keep area around the mixer clear of obstructions which could cause persons to fall onto moving parts.
■ALWAYS ensure mixer is on level ground before mixing.
■Become familiar with the controls of the machine before operating.
■ALWAYS replace any worn or damaged warning decals.
■Ensure the drum is rotating while filling and emptying the drum.
■ALWAYS disconnect AC power plug from power source before moving mixer (electric model only).
RULES FOR SAFE OPERATION
■High Temperatures – Always stop engine and allow the engine to cool before adding fuel, oil or performing service and maintenance functions. Contact with hot components can cause serious burns.
■NEVER disconnect any "emergency or safety devices". These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death! Disconnection of any of these devices will void all warranties.
■If mixer is equipped with an electric motor, operate only at 120 VAC, 60 Hz.
■Make sure the OFF/ON power switch is always in the OFF position before inserting the mixer's power plug into an AC receptacle (electric model only).
Maintenance Safety
■NEVER lubricate components or attempt service on a running machine.
■ALWAYS allow the machine a proper amount of time to cool before servicing.
■Keep the machinery in proper running condition.
■Fix damage to the machine immediately and always replace broken parts, or missing decals.
■Dispose of hazardous waste properly.Examples of potentially hazardous waste are used motor oil, fuel and fuel filters.
■DO NOT use food or plastic containers to dispose of hazardous waste.
■DO NOT pour waste, oil or fuel directly onto the ground, down a drain or into any water source.
MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (11/07/05) — PAGE 9